0
The Daewoo Malfunction Indicator Lamp comes on for a bulb check when you turn the ignition switch to the 'on' position. The light should then go out when you start the car. If the light stays on, it means a problem was detected. One possible problem is that either the connectors or the harness shorted out, or that the circuit is open. It is also possible that the bulb needs to be replaced. In many cases, the cause is either an exceptionally high or low amount of voltage being sent to the ECM through the MIL at a time when the bulb should not be lit up.
What else can I help you with?
What is diagnostic code P0650?
Malfunction indicator lamp control circuit malfunction
How can you reset malfunction indicator lamp?
To reset your malfunction indicator lamp start your car then you hire fps russia to blow up your piece of terrible car and buy a new one simple actually.feces
What is obd code p1700?
P1700....Malfunction Indicator Lamp requested by trans control module
2001 Buick centery has two Malfunction Indicator Lamps why?
my century buick 2001 fail inspection because of a mil malfunction indicator lamp control cicuit how can it be fix also i also seen sumthing said it had to two indicator lamps
Why is the malfunction indicator lamp on Honda Pilot lit up?
This light could be on due to a defective fuel cap.
Where is the button on a 1995 Toyota corolla to reset the malfunction indicator lamp?
its on your rear end and armpit loser hair
What is diagnostic trouble code p0650 mean?
Trouble code P0650 means:Malfunction indicator lamp control circuit malfunction
What does a malfunction indicator lamp mean?
it means one of the computers on the car has seen a malfunction, and has set a code. everything from a loose gas cap to a severe engine misfire can turn that light on
What is odb code p0650 for 2000 cady?
Trouble code P0650 means:Malfunction indicator lamp (MIL) control circuit malfunction
Honda 2003 Malfunction Indicator Lamp?
go to the dealer thy can tel you for sure why it is on could be oxygn sensor failur very comon on civics if that is the model
How do you fix a Malfunction indicator lamp control circuit malfunction?
To fix a Malfunction Indicator Lamp (MIL) control circuit malfunction, first, use an OBD-II scanner to retrieve any diagnostic trouble codes (DTCs) that may indicate the specific issue. Next, inspect the wiring and connectors associated with the MIL circuit for signs of damage, corrosion, or loose connections. If necessary, repair or replace any faulty components, and clear the codes from the vehicle's computer. Finally, perform a test drive to ensure the MIL operates correctly and the issue is resolved.
Information on Toyota Camry Malfunction Indicator Lamp?
Umm. . . I would read the manual first ,but from experience the light might not turn off because of the gas cap not on right or tight enough something clogged in the motor or just on from last malfunction but might just be broken and on
