0
What else can I help you with?
Do you put grease on a wheel hub bearing on a 1998 Chevy blazer?
No. That is a factory sealed bearing.
Where are the Grease fitting for 1998 ford ranger?
Factory version is not greasable. What I did was buy a large syringe, filled it up with grease and "injected" it into the rubber boot. NO MORE SQEAKING.
How do you replace the throw out bearing for a 1998 Jeep Wrangler?
you have to take the tran out. then it will slide off
Does the 1998 Dodge Neon only have 1 grease fitting per side?
Yes, there are only grease fittings on the lower control arm ball joints one each side. It seems that some were delivered with these grease fittings and some just had thread plugs instead.
Why are there no grease fitting for the ball joints on 1998 Achieva sl?
cause there a sealed unit, no grease. When it fails you replace the whole assembly. They are quik to do for the garage but able to charge a premium on the parts and labour on a job that may only take 30 min. its all dirty $$$$
How do you grease fittings on a 1998 fordtaurus se?
The original parts had no grease fittings.
How many grease fittings are there on a 1998 Chevy Suburban?
There is 11 grease fittings in the front end parts. You have 1 fitting in the front driveshaft, could have 1 in each u-joint. There may be fittings in the rear drive shaft too. There is 11 in the front Suspension for sure, and that is not counting the driveshafts.
Is there a clutch adjustment procedure for the 1998 Jeep Cherokee 6-cylinder 5-spd Throw-out bearing seems to be riding on the pressure plate?
No, the hydraulic system is self adjusting.
How do you change the wheel bearing on a 1998 Honda Accord ex?
how do you change a 1998 Honda accord front wheel bearing
Change 1998 jimmy 4x4 front wheel bearing?
How do you change a 1998 jimmy 4X4 front wheel bearing ?
When should you grease your front wheel bearings on a 2x2 1500 Ram Dodge?
The front bearings on Dodge Rams after 1998 are all sealed and non serviceable. If you have an older Ram with serviceable bearing, every 50000
Tips on changing front brake pads on your 1998 infiniti QX4?
use new pads and shims, repack wheel bearings and replace grease seals, set factory bearing tension, and resurface/replace rotors.
