quickly
Door Trim RemovalTo remove door trim on '91 model NISSAN PINTARA you have to unscrew the handle (two Philips head screws). next take off plastic surounding door release (it just clips on). then this part is tricky - you might need two flat blade screwdrivers to remove the W clip that holds the window winder handle (unless you have power windows)! after you remove the winder handle just carefully pull on the edges of the door trim to pull the clips off the door all the way around! presto the door trim comes off! just reverse process to put it back on!
To remove the rear seat of a 1990 Nissan Stanza, start by locating the seat bottom clips or bolts at the front edge of the seat base. Use a flathead screwdriver or wrench to release these fasteners. Next, lift the seat bottom upwards to detach it from the rear brackets. Finally, for the seat back, locate any bolts or clips securing it to the body and remove them before lifting the seat back out.
At the back of the engine there is a container you pour it into.
Seat bottoms just pop up, has clips. seat back have bolts to remove. Need to remove bottom first.
To remove a 1993 Nissan maxima rear speakers you will have to remove the seat back, you will need a wrench to remove both of the bolts on each side. The seat will move once done, and then pop the parcel shelf trim. The speakers should come out.
Remove the belt from your 1990 Acura Legend alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.
just 2 simple yellow clips under seat pull them and its out
* Remove the seat cushion by pulling out on the retainer then pull up sharply on the cushion.After removing the cushion remove the bolts and lift the seat back out
How can remove the rear seat on a 1990 mercury sable
well i am the one that asked the question but i actually figured it out for most single cam cars just allign the crank shaft on top dead centre and on the cam shaft just point the marker or dot down towards the centre of the crank pully and fit the belt back on. easy as that!
Open the tailgate. About 5" back from where the tailgate closes, there are two 10mm screws on the edge.
The 1990 Chevy Corvette front drivers side speaker cover will need to be removed. Remove the speaker retaining screws. Remove the wiring harness from the back of the speaker.