answersLogoWhite

0

remove the engine and transmission from the car, then remove engine flywheel and it will be right there

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Where is the crank shaft sensor on a suzuki aerio 03?

On a 2003 Suzuki Aerio, the crankshaft position sensor is typically located near the bottom of the engine block, close to the crankshaft itself. It is usually mounted on the engine's front or side, often near the timing cover. To access it, you may need to remove some components for better visibility and workspace. Always consult a repair manual for your specific vehicle for precise location and removal instructions.


How do you check the camshaft position sensor on a 2002 suzuki aerio?

To check the camshaft position sensor on a 2002 Suzuki Aerio, first, locate the sensor, which is typically near the camshaft on the engine. Disconnect the electrical connector and use a multimeter to measure the resistance between the sensor terminals; refer to the vehicle’s service manual for the specific resistance values. Additionally, you can check for proper voltage supply to the sensor while the engine is running. If the readings are outside the specified range, the sensor may need replacement.


Where is the mass air flow sensor on a suzuki aerio?

trottle body


What is the part number for Suzuki Aerio Mass Air Flow Sensor?

The part number for the Suzuki Aerio Mass Air Flow Sensor typically is 22880-81A00. However, it's always recommended to verify the part number with a dealership or an official parts supplier, as variations may exist based on the year and specific model of the Aerio.


How do you change spark plugs 2005 suzuki aerio?

Sell it !!!


How do you remove abs sensor on a suzuki aerio 2006?

To remove the ABS sensor on a 2006 Suzuki Aerio, first, ensure the vehicle is safely elevated and supported. Disconnect the negative battery terminal, then locate the ABS sensor on the wheel hub. Remove the mounting bolt securing the sensor, gently pull it out from the hub, and disconnect the electrical connector. Replace the sensor or reinstall it as needed, ensuring all connections are secure before reconnecting the battery.


Where is the oxygen sensor on a 2006 Suzuki Aerio?

On a 2006 Suzuki Aerio, the oxygen sensor is typically located in the exhaust system. There are usually two sensors: one upstream (pre-catalytic converter) and one downstream (post-catalytic converter). The upstream sensor is located near the exhaust manifold, while the downstream sensor is situated closer to the catalytic converter. To access them, you may need to lift the vehicle for better visibility and access.


Why is the air bag sensor light on in the Suzuki Aerio if there has never been a collision?

Are you sure it never was in a collision? My car fax on my aerio was clear yet my air bags were missing. Thanks Drive Time the goto guys for ripping people off....


When was Suzuki Aerio created?

Suzuki Aerio was created in 2001.


When should a timing belt on a 2004 Suzuki Aerio be changed?

its a chain not a belt.... True. So unless it breaks, you don't have to change it.


Where can you find a fuse diagram for a 2003 suzuki aerio?

under hood fuse and relay diagram for 2002 suzuke aerio


How do you replace a transmission filter for a suzuki aerio?

How do you replace a transmission filter for a suzuki aerio SX 2006 ?Read more: How_do_you_replace_a_transmission_filter_for_a_suzuki_aerio