answersLogoWhite

0

Do not stop on the ramp get on the gas and go if you have some where you can go at all and use your turn signal.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

You were reversing and a driver who was suppose to give way to join the road you were parked did not stop and you hit his car at top of front tire while mine got damaged at rear bumper. whose fault?

You were at fault. It was your responsibility to make sure the way was clear for you to enter the flow of traffic. In General, any vehicle that is already in the flow of traffic and obeying posted rules will be considered to have the right of way. If you are attempting to enter the traffic flow then you are required to yield to that flowing traffic. BTW: One should never "reverse" into traffic


What If the aircraft's radio fails what is the recommended procedure when landing at a controlled airport?

Observe the traffic flow, enter the pattern, and look for a light signal from the tower.


When entering or merging with highway traffic should you enter at the same speed a slower speed or faster than the traffic that is moving?

When entering or merging with highway traffic, it is safest to match the speed of the traffic already on the highway. This helps to maintain a consistent flow and reduces the chances of causing a disruption or collision.


What is a freeway ramp meter?

A freeway ramp meter is a traffic management device located at on-ramps to control the rate at which vehicles enter the freeway. It regulates the flow of traffic by controlling when vehicles can merge onto the freeway, helping to improve traffic flow and reduce congestion. Drivers must wait for a green light before proceeding onto the freeway.


What is the main purpose for traffic signs?

To regulate the flow of traffic.


When using an acceleration lane to enter the free way?

Accelerate to match the speed of traffic before merging onto the freeway. Use your turn signal to indicate your intention to merge, and check for a safe gap in traffic. Merge smoothly and steadily into the flow of traffic at a safe speed.


What is the meaning of traffic counter flow?

Traffic moving the opposite direction of most other traffic


How do you control traffic flow during construction?

To control the flow of traffic during construction, it's best to have signs posted for drivers to know what is coming up the road. Next, have cones to guide the traffic and an flag person ready to signal which flow of traffic can move.


What allows traffic to enter and leave highways with fewer interuptions?

Ramps and interchanges provide access points for traffic to enter and exit highways with minimal interruptions. These features allow vehicles to merge onto and off of the highway smoothly, reducing the need for sudden stops or delays. Proper design and engineering of ramps and interchanges help to improve traffic flow and overall efficiency on highways.


When you enter traffic from a stop position always yield the right away to?

When you enter traffic from a stopped and position, always yield the right of way to


What has the author Pierre Dersin written?

Pierre Dersin has written: 'Propagation of disturbances in traffic flow' -- subject(s): Traffic flow


What is the importance of traffic lights on busy streets?

To control traffic and allow traffic to flow in an orderly fashion.