0
CHECK YOUR WIRING DIAGRAMS TO BE SURE YOU DON'T NEED A RELAY.
Make sure your switch can handle the amperage on the starter circuit!!!
Buy a multimeter (if you don't have one).
Put it on Volts DC.
Go to the back of your ignition switch.
Find the constant 12 volt wire (always hot).
Turn the key to accessory and find which wire now has power (this is your accessory).
Turn the key to "on" and find which wire has power now (this is your ignition wire).
Only one wire should be left, this is your starter wire.
Now disconnect the battery
To start with key
Tap into the ignition wire and run a wire to the POWER terminal on the switch
Tap into the starter wire and run another wire to the ACC side of the switch
To start without the key
Tap into the always hot wire and run a wire to the POWER terminal on the switch
Tap into the starter wire and run another wire to the ACC side of the switch
If your button is illuminated, you will also need to run a ground wire to the switch
CHECK YOUR WIRING DIAGRAMS TO BE SURE YOU DONT NEED A RELAY.
What else can I help you with?
How in the 2011 kia sorento is the ignition put into ACC mode for push button start vehicles?
Press the ENGINE START/STOP button once without depressing the brake pedal
Ford Mondeo lx 2.0 diesel engine on and off?
Depress clutch and press starter button to start engine, to stop engine just press start button.
How do you start a diesel generator engine it has ran out of fuel?
Put diesel fuel in it !... Then either press the starter button or pull the starter cord !
How do you start a tvr tuscan?
Starting the Engine 1 Apply the handbrake and insert the immobilser key into the lock situated on the side of the centre pod. 2 Depress the clutch pedal. Put the gear lever into neutral. 3 Press and release the start / stop button. The ignition lights will illuminate and the button will light green. If the immobilizer is on (if it is more than 10 seconds since you unlocked the car) press the black key fob button once. 4 Press and hold the start / stop button for approx 2 seconds until the engine starts then release the button. The engine will start (minimal use of the throttle pedal may be needed during the engine start sequence.) 6 To stop the car press and release the start / stop button.
How airplane start with key or button?
A key to start the engine then buttons and levers to control flying.
How do you program avital remote start?
You can program the remote start by holding the start button down for 10 seconds. The start light will illuminate. With the start light illuminated hold the start button down until the engine start.
Can you provide me with instructions on how to start the car?
To start the car, first make sure the car is in park or neutral. Insert the key into the ignition and turn it clockwise until the engine starts. If your car has a push-button start, press the brake pedal and then press the start button. Make sure to release the key or button once the engine is running.
How do you start a Honda four wheeler?
Turn the key on. Put it in neutral and press in the start button.
How does a SI engine works?
You put petrol in it, start the engine, and it goes.
How do you start a Suzuki c90?
You need to put the key in the ignition, turn the ignition on, shift to neutral, turn on engine safety switch, wait for fuel pump to cycle, hold the clutch in, and press the start button. If the bike will not start, it may be your battery.Ê
Is there a button to push when a 2002 Chrysler Sebring engine does not start even with brand new battery?
NO, Dodge doesn't have a reset button.
How do you put cheats into need for speed under ground2?
where you press the start button.
