I machined some polycarbonate (Lexan) sheets that dated from 2005 and the white plastic protective film had become very brittle and virtually impossible to remove. Not wanting to do the work again, I tried a few ways to remove the film. A plastic scraper seemed the only way until I heated the film with a domestic hair-drier set to hot. The protective film was softened enough to become very pliable and it came away from the polycarbonate sheet with only a gentle continuous pull, taking care not to disrupt the film as is was released from the sheet. Any marks left by the plastic scraper where the film had to be 'started' were removed with acetone (nail polish remover); polycarbonate is impervious to acetone. Check your sheet is polycarbonate before using any solvent (check some waste or inconspicuous part of the sheet beforehand). Hope this works - it did for me.
You need warm water to remove a sticky mirror from the locker.
Polyurethane is not typically sticky when applied to surfaces. It dries to form a hard, protective coating that is smooth and durable.
A number of different utensils are used to remove sticky ingredients, including forks, spoons and tongs.
If sticky label remove the top part then go over the sticky residue left with either selloptape or masking tape.
Pull it off then use Lift-Off to remove any sticky stuff
wd40 removes sticky tape residue from laminate floors
You can use vegetable oil to remove sticky tags from a puppy's paw. This is a safe and effective method and will not harm your puppy if ingested.
To remove sticky residue from leather, take plain dish soap and a wet rag. Add a dab of the soap to the rag and scrub away the residue.
The best way to remove a sticky residue from plastic is to use a gentle emulsifier. A gentile antibacterial soap and a soft bristle brush can normally get rid of a sticky residue.
Soak the paper with spirit ( ethyl alcohol) and then remove the sticky tape.
goo gone
vegtable oil