TAke the knobs off and there are nuts under them that need to be removed.
To remove the radio from a 2003 Saturn Ion, first disconnect the negative battery terminal to ensure safety. Next, use a flathead screwdriver or a trim removal tool to carefully pry off the trim panel surrounding the radio. Once the trim is removed, unscrew the bolts securing the radio in place, then gently pull the radio out of the dashboard. Finally, disconnect the wiring harness and antenna cable from the back of the radio.
To remove the radio from a 1995 Honda Odyssey, start by disconnecting the negative battery cable to avoid electrical issues. Next, carefully pry off the trim panel surrounding the radio using a flathead screwdriver or trim removal tool. Once the trim is off, remove the screws securing the radio, then slide it out of the dashboard and disconnect the wiring harness and antenna. After that, you can replace or service the radio as needed.
To remove the stock radio from a 1995 Holden Barina, first, disconnect the car battery to ensure safety. Then, use a flathead screwdriver to gently pry off the trim surrounding the radio. Once the trim is removed, unscrew the mounting screws holding the radio in place, and carefully slide the radio out. Finally, disconnect the wiring harness and antenna cable from the back of the radio.
To remove the radio from a 1995 GMC Vandura van, first disconnect the vehicle's battery to ensure safety. Then, carefully pry off the trim panel surrounding the radio using a flathead screwdriver or trim removal tool. Once the trim is removed, unscrew any mounting screws holding the radio in place, and gently pull the radio out of the dashboard. Finally, disconnect the wiring harnesses and antenna cable from the back of the radio to complete the removal.
The trim on either side of the radio needs to be removed This is best done with a trim removal tool Once the trim is off you will see two bolts each side of the radio Remove these and the unit is out
to remove your radio you need to remove the dash trim first... remove every screw you can find in the dash trim (plastic trim) most of the screws are on the bottom and near the ashtray the top snaps into place (try pulling downward on the trim after you remove all the screws). once you have this removed, there are 2 screws top and bottom of the radio, remove them and the radio will come out, the rest is easy.....
remove the screws holding on the trim, remove the ashtray(should slide out) then remove the trim peice, then unscre the mounting bracket. Then unscrew the radio from the bracket and unplug the wiring harness.
To replace the radio antenna on a 1998 Saturn sedan, first, ensure the vehicle is turned off. Carefully remove the plastic cover or trim around the antenna if applicable, and unscrew the antenna from its base, typically located on the roof. Disconnect the antenna cable from the radio, then connect the new antenna and secure it in place. Finally, replace any trim or covers and test the radio to ensure proper reception.
To remove the radio from a 1995 Saab 900S, first disconnect the car battery to prevent any short circuits. Use a flathead screwdriver to carefully pry off the trim panel surrounding the radio. Once the trim is removed, locate the screws securing the radio and remove them. Finally, gently pull the radio out of the dash, disconnect the wiring harness, and you're done.
To remove the factory radio from a 1995 Chrysler Cirrus, first disconnect the negative battery cable to prevent any electrical issues. Then, carefully pry off the trim panel surrounding the radio using a flathead screwdriver or a trim removal tool. Once the panel is removed, unscrew the bolts securing the radio in place, then gently pull the radio out and disconnect the wiring harness and antenna cable from the back. Be sure to handle all components carefully to avoid damage.
Remove the trim panel around the radio, it just snaps in. Then there are 2 bolts that hold it in. They are 10mm. Once removed just pull the radio straight out. You may need to giggle it a bit as it is a close fit. Remove the 2 connectors and the antennae wire. You're done.
To remove the dash to get to the radio from a 2005 Kia Optima, begin by prying around the edge of the trim around the gear shifter. Then, remove the screws from the bottom of the dash and pry the trim away from the radio area. This will expose the radio bezel.