answersLogoWhite

0

drain the oil, remove the oil pan, remove rod cap

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What is PARTS of a piston in a petrol engine?

The piston includes the piston, rings, rod, rod bearing, and crankshaft bearing.


How are the rods from a piston are made?

They are cast and then the ends are machined to accept a bearing and the pin that holds the rod to the piston.


What would cause a knock in your lower end above your oil pan on a 96 Dodge 318?

Rod bearing, cracked piston, loose wrist pin, etc.Rod bearing, cracked piston, loose wrist pin, etc.


What does a knocking sound in the engine means?

Typically.... Connecting rod bearing / crank bearing. But it could also be piston slap, or flywheel.


How do you replace a rear tire bearing?

rear ryhits bearing


How do you replace a piston on a 1995 Nissan Maxima?

Remove engine, disassemble, replace piston, re-assemble engine and install. Good times!


What is the function of gudgeon pin in a piston?

The gudgeon pin or wrist pin (as it is called in the US), connects the piston to the connecting rod and provides a bearing for the connecting rod to pivot upon as the piston moves.


How do you replace a throw out bearing in a BMW 330ci?

To replace a throw out bearing in any car or truck you must remove the gearbox, then remove the clutch, then pull the bearing out of the flywheel and replace it. Assemble in reverse order.


Do you need to replace the wheel bearing when replacing brake discs on a mark 4 golf gti?

no need to replace wheel bearing unless the wheel bearing is worn out


How do i replace therear wheel bearing on a Chevy pick-up?

how do you replace the rear wheel bearing on a Chevy pick up


How do you replace front wheel bearing on 1996 Hyundai Elantra?

how to replace front wheel bearing on 1996 Hyundai elentra


Is it hard to replace piston?

It is just about the hardest most difficult part of an engine to replace. The engine has to come out. The head has to be taken off. The rod of the piston has to be disconnected from the crankshaft. the top of the cylinder has to have a ridge reamer operated on it to get the piston out.