0
What else can I help you with?
Transmission fluid for 1989 Pontiac sunbird 2.0 automatic?
The most current specified and downwardly compatible automatic transmission fluid (ATF) for the 1989 Pontiac Sunbird with the 2.0L 4-cylinder engine (Vin "K") is GM Dexron VI.
How do you replace the automatic shift knob on an 1989 Mustang LX 2.3L?
The knob on a shifter for a 1989 Mustang LX 2.3L can be replaced by unscrewing the old knob and putting on a new knob. On many shifters, this knob can be replaced with an aftermarket version.
Where is the backup light switch on a 1989 GMC pickup with automatic transmission?
It is combined with the neutral safety switch and mounts to the transmission where the shifter linkage is attached.
How do you get shift nob off the shitfter 1989 Honda accord?
If you have amanual transmission You have to push down on the plastic ring above the shifter boot. after you push down the ring, Now you can unscrew the shifter knob. IF you have a automatic transmission you have to remove the screw on the side of the shifter knob. (Be careful the button on the shifter knob is spring loaded)
How do you replace the front turn signal bulb located on a 1989 Pontiac Sunbird?
On some cars the bulbs screw in from the rear and you have to take the light assy off to get to it.
1989 Pontiac sunbird?
What's exactly the question is?
How do you install a started on a 1989 sunbird?
very carefully
Top speed of a 1989 Pontiac sunbird automatic 2.0 4-cylinder?
my 1997 with the 2.0 mpfi tops out at 138 on flat ground. exhaust mod and cold air intake. nothing else.
Where is the crank sensor on a 1989 Pontiac sunbird 2.0?
Crank sensors are always located on the camshafts. The 1989 Pontiac Sunbird crank sensor is located on the head of the engine towards to end of the camshaft.
Where is the fuel pump on a 1989 Pontiac Sunbird LE?
Fuel tank.
How do you replace headlamps on 1989 Pontiac Sunbird GT with 2.0L Turbo?
To replace the headlamps on a 1989 Pontiac Sunbird GT with a 2.0L Turbo, first, open the hood and locate the headlamp assembly. Remove the retaining screws or clips that hold the headlamp in place, then carefully pull the headlamp assembly forward. Disconnect the wiring harness from the back of the headlamp and replace the old bulb with a new one, ensuring it’s securely connected. Finally, reassemble the headlamp assembly and test the new bulbs to ensure they work properly.
What is the firing order for a 1989 Pontiac Sunbird?
1 3 4 2
