The tailgate latch comes off with the cable. It is one piece.
Where is the blend door actuator on a 1998 Sonoma
The starter on a 1998 GMC Sonoma is replaced by disconnecting the battery, removing the outer cover, and unbolting it from the engine. The wiring harness can then be disconnected, the starter removed, and a new one put in place.
You need to order the part(s) first, which you can do at your local Toyota dealership or at an auto parts store. Then, you simply disassemble the tailgate, remove the defective latch component, and put in the new part, and then reassemble the tailgate.
I just went through this , forget it ! get the part from a junkie and have your mechanic replace it , not worth the trouble
To repair the tailgate bottom latch on a 1998 Toyota 4Runner, first, remove the plastic cover from the tailgate to access the latch assembly. Inspect the latch for any broken parts or misalignment; clean and lubricate the mechanism if it appears dirty or rusty. If any components are damaged, replace them with new parts. Reassemble the tailgate and test the latch to ensure it operates smoothly.
Sonoma Valley Museum of Art was created in 1998.
Haartsen and Mattisson (working at Erricson) created it in 1994 to try to replace cables.
I believe it is 2 torx screws inside the tailgate holding the assembly. Have to replace the whole assembly.
To fix the rear hatch door cables on a 1998 Ford Windstar, first, remove the interior panel of the hatch to access the cables. Inspect the cables for any damage or disconnection, and if necessary, replace them with new cables. Reattach the cables to their respective anchor points, ensuring they are properly secured. Finally, reassemble the interior panel and test the hatch to ensure it opens and closes smoothly.
r-134a
If its the cables inside you need to remove the panels and replace the cables. You can in a pinch just disconnect them from the handle. Then pull them to release the door.
Inside the transmission