Prees odo meter button down and turn on ignition wait 10 seconds
To reset service light on Toyota Auris one can activate the code error reader which is a diagnostic tool. You can also hold down the odometer reset button.
there is no reset button there is a circuit opening relay under the dash you can check it with an oms meter
Beaverton Toyota, Oregon, provides a list of the steps to reset the service indicators for a variety of Toyota models, also Scion. Go to: How To Reset Maintenance Light ( http://www.beavertontoyota.com/service/tips.htm ) Find your make and year, and go to the list, thus ... --- "Reset Engine Oil Replacement Reminder Light" --- Find your model and follow the detailed steps. For 2008 Avalon, the list is at: http://www.beavertontoyota.com/service/pdf/08maintlight.pdf
Beaverton Toyota, Oregon, provides a list of the steps to reset the service indicators for a variety of Toyota models, also Scion. Go to: How To Reset Maintenance Light ( http://www.beavertontoyota.com/service/tips.htm ) FIND your make and year, and go to the list, thus ... --- "Reset Engine Oil Replacement Reminder Light" --- FIND your model and follow the detailed steps. For 2008 Avalon, the list is at: http://www.beavertontoyota.com/service/pdf/08maintlight.pdf
How do you reset maintenance reminder light on 2008 Toyota corolla? For what it is worth: To reset the Maintenance Required light on my 2007 Toyota Corolla: 1) Set your trip meter to the odometer setting (in other words, not Trip A or Trip B) 2) Hold down trip meter reset button and turn ignition to off. 3) While holding down the trip meter reset button now turn the ignition to on. 4) Keep holding down button until Maintenance Required light shuts off. Note: One some other Toyota models you hold down the Trip A meter rather than the odometer. Hope this works for you.
To reset the oil change light on a Toyota Highlander 2012, switch the engine to the OFF position. Then switch the engine back on while pressing the trip meter reset button until it displays 000000 or says COMPLETE.
How do reset immobilizer toyota hice
To reset codes on a Nissan forklift, first, turn off the ignition and ensure the forklift is in a safe position. Next, locate the diagnostic connector and use a jumper wire to connect specific terminals, usually the diagnostic terminal and the ground. Turn the ignition key to the "ON" position without starting the engine, and wait for the warning lights to flash, indicating the codes are being reset. Finally, remove the jumper wire and turn off the ignition to complete the reset process. Always consult the specific model's service manual for precise instructions.
turn key to on without cranking the engine then press the trip meter lever for a few seconds until the meter reads zero
turn key to on without cranking the engine then press the trip meter lever for a few seconds until the meter reads zero
Turn ignition key to the 1st position, and then push and hold the trip meter reset stem, then, while continuing to hold the trip meter pushed in, and after no more than 2 seconds, turn the ignition key to the 2nd position and continue to hold the trip meter reset pushed in until the service light begins flashing. Once it begins flashing, you can release the trip meter. You may also get an audible signal when complete.