Some vehicles have a reset button on the passenger side under the dash, you need an inside of a pen or piece of wire read your owners manual!
how do I reset my service engine light on my 1999 ford f150
press reset for tripmeter for a few seconds
why appear light ( service engine soon), after change oil on a 2001 ford pickup (f150)?
My experience has been that if you disconnect the battery cables and leave them off for a minute, then reconnect them, the service engine light should have reset.
To reset the service light on a BF Ford Falcon, first turn the ignition key to the "ON" position without starting the engine. Press the accelerator pedal fully to the floor three times within five seconds. Then, turn the ignition off and back on again to check if the service light has been reset. If the light remains, repeat the process.
To reset the service light on a 2009 Ford Transit van, turn the ignition key to the "On" position without starting the engine. Press the accelerator pedal three times within 10 seconds. Then, turn the ignition off and start the engine to check if the service light has reset. If the light remains on, repeat the process or consult your owner's manual for further instructions.
how do reset the airbag light on a 94 ford escort
disconnect battery for 5 minutes, and then reconnect
To manually reset the "Service Engine Soon" light on a 2005 Ford Explorer, you can disconnect the battery by removing the negative terminal for about 15 minutes. This will reset the vehicle's computer and clear the light. Alternatively, you can use an OBD-II scanner to erase the trouble codes that triggered the light. Always ensure that any underlying issues are addressed before resetting the light.
Hi, Assuming it is a EF / EF Falcon - May work for EA - BA Ford EF / EL Falcon - Turn of service reminder light Insert Keys Press odometer button and hold Turn key to ignition position (Lights on) Hold odometer button until you hear a beep · Service Light Is Reset
2000 F150 Harley-Davidson
disconnect batteries for 30 sec. and then reconnect and that will do the trick