- Iginition OFF (POS 0)
- Press and Hold the trip odometer button while turning key to position 1 (ACCESSORY)
- Keep the button depressed (about 5 secs.) until you see "Oil Service" or "Inspection" with "Reset" or "Re" in the display
- *Note: On vehicles with "High" cluster, you will also see the amount of fuel (in litres) remaining until next service
- Press the button again and hold for approx. 5 secs. until "Reset" or "Re" flashes
- While the display is flashing, briefly press the button again to reset the Service Interval. After the display has shown the new interval you should see "END SIA" for about 2 secs.
Note that if the "Reset" or "Re" does not flash, then you have not met the minimum consumption level and cannot reset.
To manually reset the service engine soon light on a 2000 BMW Z3, you can use the following steps: First, turn the ignition key to the "On" position without starting the engine. Then, press the gas pedal fully three times within five seconds. Finally, turn the ignition off, and the light should be reset when you start the vehicle again. If the light stays on, there may be an underlying issue that needs to be addressed.
How does one reset service engine light on 2000 Nissan Quest Thanks Bill
In order to get your SRS Service Airbag light reset, You have to go to the Volvo dealership.
no reset switch in this system
In order to reset the service light on a 2000 reg Megan you\'ll need to start by turning the ignition switch to the "On" position without starting the engine. Once the service light appears on the dashboard you can reset it by following these steps: Press and hold the odometer reset button Turn the ignition switch to the "Off" position Release the odometer reset button Turn the ignition switch back to the "On" positionAfter following these steps the service light should reset and no longer appear on the dashboard.
2000 F150 Harley-Davidson
Under the hood on the drivers side, there is a main electrical box. There should be a reset botton there.
put tape over lite jtyj
That requires an OBDII engine scanner.
Key on, close doors. Press "step" until "0 miles to service" is displayed. Press and hold "reset".
how to reset abs warning light on 2000 gmc Yukon
you reset it by hitting step until you see "miles remaining to service" then you hold reset button and it will change to 3000