To replace the hub bearing on a 2002 Bravada, first, safely lift and support the vehicle. Remove the wheel, brake caliper, and rotor to access the hub assembly. Disconnect any necessary components, such as ABS sensors, and unbolt the hub from the steering knuckle. Finally, install the new hub bearing, reassemble the components, and torque everything to the manufacturer's specifications.
The front wheel bearing hub nut on a 2000 Oldsmobile Bravada typically requires a 36mm socket for removal and installation. It's important to ensure that the nut is properly torqued to the manufacturer's specifications after replacement. Always consult the vehicle's service manual for specific details.
the blazer or jimmy hub and bearing assembly should work on your 96 bravada they are basically similar vehicles
nO
Identical bearing replacement procedure to a 307
Of course there are bearings, how else would the wheel turn. Fortunately you can buy the entire hub assembly which is only held on by 4 bolts, so no bearing removal or replacement into the core. This is about 45-$60.
No.
http://www.paulstravelpictures.com/GM-Wheel-Bearing-Hub-Assembly-Replacement/index.html
To remove the rear wheel bearing from a Chevrolet Bravada, first, lift the vehicle and secure it on jack stands. Remove the rear wheel and brake components, then disconnect the axle shaft if necessary. Use a bearing puller or slide hammer to extract the bearing from the hub assembly, ensuring you clean the area before installing the new bearing. Always refer to the vehicle's service manual for specific torque specifications and procedures.
Changing wheel bearing from a 2002 Hyundai Elantra requires removing the hub assembly. The bearing will need to be pressed out and in to confirm and safe install.
change hub bearing assbly
To replace a wheel bearing on a 2000 Olds Bravada, first lift the vehicle and remove the wheel. Next, detach the brake caliper and rotor, and then remove the axle nut and any components obstructing access to the wheel bearing. Use a bearing puller to remove the old bearing from the hub assembly, install the new bearing, and reverse the disassembly steps to reassemble everything. Ensure all components are torqued to the manufacturer's specifications and check for proper function before lowering the vehicle.
If you take the left front wheel off and the outer casing of the four wheel drive hub and see missing bearings, then it is the wheel bearing. If the bad bearing is in the part that you removed, the hub locker, then it will require replacement. I am wrestling with a bad wheel bearing & hub now myself, on a 93 Tracker 4wd. I need a place to buy parts. I can't find the hub anywhere. I found my new replacement wheel hub @ Autozone. $96.00 + tax.