You need to replace the rubber seals in the master cylinder. May even have to have the master cylinder re-sleaved.
The slave cylinder for the hydraulic clutch on a manual transmission is located inside the manual transmission bell housing
Wuzzles - 1985 Klutz on the Clutch 1-6 was released on: USA: 19 October 1985
You have a hydraulic clutch in your mr2, no cable.
According to Ford Fleet Maintenance, the 1985 Ranger's GVWR is 3,001-4,000 pounds.
A 1985 Ford Ranger ( all engine sizes ) came WITH and WITHOUT air conditioning
no adjustment on hydraulic clutch, worn clutch disc and pressure plate
When you release the clutch, you apply load to the engine. Running rich and black smoke when a load is applied are indicative of a need for a full tune-up (new spark plugs, air filter, etc).
I have a 1985 dodge pickup with a 225 slant six and a 3 speed overdrive transmission how do i adjust the clutch.
Could be a bad starter solenoidCould be a bad neutral or clutch safety switch if so equipped
Remove the fan itself then remove the clutch from the fan
I'm not a mechanic / technician , but it sounds like your clutch disc isn't disengaging completely when you push your clutch pedal in , so it sounds like a slave cylinder / throwout bearing problem. ( you could try starting it in neutral until the problem is repaired , at least the vehicle won't jump )
the Winchester ranger was made between 1985-2006.