0
What else can I help you with?
According to the warning in your lesson you should not work on manifold connections and fitting until?
the water heater cools down.
Where to locate a water sensor on a 1970 Chevy 350?
If you mean the sending unit for the water temp, it should be on the intake manifold near the gooseneck for the top radiator hose or on the drivers' side of the block somewhere near (below) the exhaust manifold. Look for a fitting that screws into the block or manifold that has 1 wire coming out of it.
Why do your rotors have small grooves after installing new rotors and brakes?
Your rotors had the grooves before, from the old pads. You should have had them turned. Next time check rotors at time of fitting new pads. If you can see or feel grooves then they should be repaired.
Why would a vortec 350 have vacuum at the oil fill cap?
intake manifold gaskets need replacing, i have repaired several of these
What seals the gauge line fitting to the gauge manifold?
The gauge line fitting is typically sealed to the gauge manifold using a combination of threads and a sealing material, such as Teflon tape or thread sealant. These materials help prevent leaks by filling in any gaps between the fitting and the manifold threads. Additionally, some fittings may use O-rings or gaskets to provide a more secure seal. Proper torque during installation is also crucial to ensure a tight connection.
What should I do if my broken bike helmet cannot be repaired?
If your broken bike helmet cannot be repaired, it is important to replace it with a new one to ensure your safety while riding. A damaged helmet may not provide adequate protection in case of an accident. It is recommended to invest in a new, properly fitting helmet to protect yourself while cycling.
Where is the low side fitting for the air conditoner on a Chrysler 300?
The low side will be located on the front side of the a/c manifold..........
Who should I call to get fire and water damage repaired?
We had a small fire in our basement. We need to now get this repaired. Who would I call to get the fire water damage repaired and what questions should I ask?
Why would a 1989 Cadillac ElDorado show the service engine soon warning light after the oil leak on the manifold was repaired?
probably something was left unplugged. Go to auto zone and get the codes read for free and it should tell you what it is.
Where is the temperature switch on a Nissan Pintara?
If its a CA20E engine, you will find it on top of the inlet manifold at the front, it has a blade type fitting on top...
Why would there still be a very strong exhaust smell with the windows down after a cracked manifold has been repaired?
There might be a hole in the silencer boxes.
Should you use a brass threaded male fitting to a PVC threaded female fitting?
no
