Need more details please.
disconnect your batter first. then take the 3 wires off.... then the three bolts and u should be done
pull all the motor mounts off and disconnect all the pipes and tubes and wires
its the blower motor resistor ... located under the hood on passenger side ... there is two screws holding it in .... it has a bunch of wires coming out of it ....
Connect the three wires that come out of the motor to the three supply wires that come from the magnetic contactor. Turn the power on and push the start button. If the motor turns the wrong way, shut the power off and change any two wires in the motor junction box.
You will connect the three black wires together, the three white wires together, and the three ground wires together. Use wire nuts to secure the connections. Follow the manufacturer's instructions and make sure to turn off the power before proceeding.
I belive it may be the motor control lamp. I am looking for info on this but can not find out why the light comes on.
Remove serpentine belt, remove three bolts ,an 2 wires. The alternator will pull up off the motor to remove. Put new alternator in replace bolts, replace wires, an replace the serpentine belt..
It means you are coming off the beats. Eg: canter has three beats off the pace has four beats.
Your blower motor is burned up. You need to get it replaced. Cost of motor, depending make and model and geographic location is approx 85.00 -100.00 figure roughly 2 hours for labor.
No. the plug wires are made different and the spark plugs ae NOT the correct heat range.
put the wires back in the insulating and then get some masculine tape around it and but before u do that turn it off and wear gloves
it screws in the top off the oil cooler 1/2 inch nut on top off cooler with two wires coming out off it.