answersLogoWhite

0

What else can I help you with?

Related Questions

Why would the steering wheel shake while braking?

You have a warped rotor. Brake pads need replacing and the rotors turned or replaced.


The front brakes are locking up on a 1989 Toyota Cressida after replacing calipers and master cylinoid?

Sounds like air in the brake lines or power steering fluid in the brake system instead of brake fluid.


Where is the TCM on 2002 accent?

It is under the dash/steering wheel next to the brake pedal, make sure you disconnect the battery before replacing.


Why do brake pads squeak after replacing pads?

Why do brake pads squeak after replacing pads?


No steering power or brake power Ford Explorer 1999?

No steering power or brake power ford explorer 1999?


Would a damaged steering rack cause shaking of steering wheel?

It could, if the damage has caused a loose component or the alignment to be way off.if the sterring wheel is shaking while applying the brakes then most likey the brake roters need machining or replacing


What would happen if you put brake fluid in the power steering?

Your power steering will fail because brake fluid is poor lubricant.


What is the problem when you can not steer nor brake the car 97 GMC astro its very hard t o steer the steering wheel and hard to brake its very hard when pressing the brake pedal?

For several years of the Chevy astro van had a power brake and power steering system that was linked together. Instead of a brake booster, the power steering pump provides power to the power brake system. Often, if the brake pedal would become hard to push, it is a power steering pump problem. Change the power steering pump and the power steering fluid and your problem may disappear.


Can power steering fluid be used as brake fluid?

No. Brake fluid is not a petroleum product. Power steering fluid is. Petroleum product will swell and ruin rubber part's brake system is full of rubber parts. You will destroy your brake system using power steering fluid.


How do you fix a Nissan tail light that stays on?

If you're talking about the brake light staying on, it may be either the small plastic button that pushes on the brake light switch on the brake pedal, or the brake light switch itself. If you're talking about taillights only, it may possibly be the light switch on the steering column that has gone bad and needs replacing.


Why might the brake lights not work on a 97 S10 Blazer after checking the fuses brake switch and replacing the bulbs?

AnswerMost likely the problem is in the turn signal switch on the steering column.Fold up a small piece of heavy paper or card board, and stick it in the four way flasher(front or back), on top of the steering column( red color button). This worked for me.


What does the brake caliper attach to?

The steering knuckle.