When a compressor service valve is located on the compressor discharge and is back-seated, it allows refrigerant to flow through the valve while isolating the service port from the discharge line. This configuration enables maintenance or servicing of the compressor without releasing refrigerant into the atmosphere. Additionally, it helps ensure that the system remains pressurized, minimizing the risk of contamination or air entering the system during service. Proper handling is crucial to maintain system integrity and safety.
Discharge line is the line in which the refrigerant passes through after being discharged by the compressor. Liquid line is the line located after the condenser, following refrigeration cycle. Suction line is the one that the referigerant is sucked :) in, to enter the compressor.
It is located on the discharge side of the compressor. On a 2.4L engine you will need to jack the vehicle up to get to it.
It located on the passenger side of the engine just behind the AC compressor. The service manual says you have to discharge and remove the AC compressor, however, i was able to loosen it and it gave me enough room to replace it.
The low side service port is located on the suction hose coming off the rear of the a/c compressor and the high side is located on the discharge hose coming from the condenser.......
The low pressure port (Suction) and the high pressure port (Discharge) are both located on the back side of the compressor.
A compressor is located between intake manifold and air filter.
The compressor in an AC unit is typically located outside the building, near the condenser unit.
The compressor in an AC unit is typically located outside the building, near the condenser unit.
The compressor is located outside of the house in a metal box with coils in the sides and a fan in the middle of it to blow air through the coils. the compressor should be located under one of the side panels of the box.
To check the start operation of a auto air conditioning compressor, install two jumper wires to by pass the low pressure, located near the suction line, and the high pressure switch, located near the discharge hot line. Then remove battery cable, and reconnect to reset on boasrd computer. System should start compressor. If not check the operation of the electric clutch, by also by passing the system connections.
how to replace air suspension compressor
The suction side of a GM AC compressor is located at the inlet port, where refrigerant vapor is drawn into the compressor from the evaporator. This side typically has lower pressure compared to the discharge side, which expels high-pressure refrigerant vapor. The suction line connected to this port is usually larger in diameter and may be insulated to prevent heat gain.