Body Control Module(BCM) is located inside kickboard(passenger side)
The fan sending unit is on the side near the thermostat housing.
Where is the low-side port located on a 1998 dodge neon?
The sensor will be mounted to the side of the intake manifold below the PCV valve
The low side service port on your 1993 Mitsubishi Eclipse can be found on top of the air conditioner compressor. The low side service port will be labeled as the low pressure port.
The PCV valve on a 1991 Dodge Dynasty 3.0 engine is on the passenger side of the vehicle. It is on the crankcase.
On a 1988 Dodge Dynasty, the AC low-pressure port is typically located on the accumulator, which is situated on the passenger side of the engine bay near the firewall. It is a small valve with a plastic cap, usually marked with an "L" for low pressure. To easily identify it, look for a smaller diameter line compared to the high-pressure port, which is usually larger. Always refer to the vehicle's service manual for precise locations and instructions.
The low side port on the 2001 dodge ram is near the radiator topside plain as day buddy i hope that helps you :D
Its going to be on the left side of the transaxle
The small connector in the a/c line is the low port and the big connector is the high port side ...
The location of the washer fluid reservoir on a 1992 Dodge Dynasty is in the engine compartment on the driver's side. It is a white or black receptacle near the front just above where the driver's side headlamp is.
If you mean where is the module, it would be found inside the engine air intake duct along the drivers side front fender under the hood.