answersLogoWhite

0

What else can I help you with?

Related Questions

How much oil do you put in a John Deere L130 with a 23hp kohler engine?

Hi, Roughly 2 qts. with oil filter change. Little over to top it off. Fill, crank engine, shut it off and refill to finish. Peace, crigby


What is the horse power for a Yamaha 350 raptor?

22-23hp


What Fram oil filter will fit a Kawasaki 23hp mower?

For a Kawasaki 23hp mower, the appropriate Fram oil filter is typically the Fram PH3614. However, it’s always a good idea to check the owner’s manual or consult with a local dealer for the most accurate and specific part number, as variations can exist depending on the model year and specific engine configuration.


What year was the John Deere 2305 made?

The 2305 john deere was a new model starting in 2005 It would be sold with the front bucket it is a 23hp yanmar engine 4wd and a 18hp pto


Which was the maximum speed of Renault 4 4-cylinder 23HP 1967?

The maximum speed of the 1967 Renault 4 4 cyl 23 HP was 75 miles per hour. It accelerated from 0 to 60 miles per hour in 22.6 seconds and had a 1/4 mile drag time.


What is the best rated zero turn mower?

The best rated zero turn mower is the Toro TimeCutter SS5000 23HP Kawasaki Zero Turn. The next best would be the Hasqvarna MZ5424S 24HP Kawasaki Zero Turn Law Mower.


Is a crf150r faster than a yz 85?

Well, when it comes to speed, it's not just about the size of the engine, it's also about how the bike is designed and how it feels to you. Both the CRF150R and YZ85 are great bikes with their own unique strengths. Remember, the most important thing is to enjoy the ride and have fun exploring the great outdoors!


How to fix a bad bearing on top of 23HP kawasaki motor on mower model9422223 it runs but shaft wobbles no power leaks oil out of upper seal?

I have the same problem with my 23hp kawijunk. What i have found is that when you tear down the engine you will find there is a bushing/bearing in the top of the crank case. If you look on the parts breakdown it doesnt show the bushing because kawasaki says the bushing is casted in to the block and cannot be removed. That is wrong it can be removed by pressing it out but you have to match it up with a bearing maker. I have found a part number on the internet that is PAP 40 20 p10 pl which is a INA bearing bushing but that bushing is for the bottom pan not the top bushing in the crank case. What i done was went to a local bearing dist. and found the bearing was made by INA but INA doesnt care a PAP 40 25 P10 which is what you need for the top. So i ordered a PAP 40 30 p10 and plan to have it cut down 5mm to be exact fit as origional. So if your engine is like mine the crank in mine was shot also. So the parts to fix yours will prolly be the same as mine. What you will need is a new sump pan gasket,bottom oil seal,top bushing,new crank. That should get you back in business if you dont plan on doing this work yourself it could get expensive at a shop with all the labor involved. Let me know if i can help.