answersLogoWhite

0

The starter on a 1990 Plymouth Acclaim is located on the lower side of the engine, near the transmission. It is positioned towards the rear of the engine bay, mounted to the engine block. To access it, you may need to lift the vehicle and remove any components obstructing the starter, such as the battery or heat shield.

User Avatar

AnswerBot

1w ago

What else can I help you with?

Related Questions

Where is the water pump located on a 1990 Plymouth Acclaim?

It is under the timing cover on a 3.0L


Where is the crankshaft position sensor in a 1990 Plymouth acclaim located?

It doesn't have a crank sensor. It only has a distributor pick up plate (cam sensor).


Does a 1990 Plymouth acclaim have points and a rotor?

Points, no. Distributor cap and rotor, yes.


Where is the fuel filter located on a 1990 Plymouth Acclaim?

in front of the pass rear tire its a round metal unit held by a single bolt with two hoses going into it


What type of oil to put in a 1990 Plymouth acclaim?

5w30 or 10w305w30 or 10w30


Where is the Asd on a Plymouth acclaim?

On my 1990 it is the middle relay on the left fender between the battery and the shock tower.


Where is the O2 sensor on a 1990 Plymouth Acclaim 3.0 liter 6cyl?

It is screwed into the exhaust behind the engine.


What causes the cluking in the front end of a 1990 Plymouth acclaim?

Check lower control arm bushings.


How do you remove the door panel on a 1990 Plymouth Acclaim?

Email me at:shughes@gcronline.com. I will give you what you need to know. Lynn


Where is heater core in 1990 Plymouth acclaim 2.2L?

The heater core is inside the Hvac housing, under the dash.


Where is the asd relay on 1990 Plymouth acclaim?

The ASD (Auto Shut Down) relay on a 1990 Plymouth Acclaim is typically located in the power distribution center, which is found in the engine compartment. It is usually a rectangular relay, often marked for easy identification. To access it, you may need to remove the cover of the power distribution center. If you're experiencing issues, consult the vehicle's service manual for specific diagrams and locations.


Where is the high beam switch on a 1990 Plymouth acclaim?

Pull the wiper/turn signal stalk towards the back of the car.