The front fork tube diameter on a 1996 Suzuki Intruder 1400 motorcycle is 41 mm. This measurement is important for compatibility with various aftermarket forks, tubes, and accessories. Always ensure to verify specifications with manufacturer resources or repair manuals for precise applications.
To start a Suzuki Intruder 1400, first ensure the motorcycle is in neutral and the kickstand is up. Turn the ignition key to the "ON" position, then pull in the clutch lever. Press the start button to engage the starter motor. If the engine doesn’t start, check the kill switch and ensure the fuel is on.
2000 intruder1400=70hp
The fuel pressure for a 94 Suzuki Intruder 1400 is between 40 and 48 psi. A fuel pressure gauge is needed to test the pressure.
If you're talking about the motorcycle, yes; it's on the left side, just under the lower edge of the tank, between the two cylinders.
On a 1996 Suzuki Intruder 1400, the fuses are typically located under the seat or near the battery compartment. To access them, you may need to remove the seat or a side panel. The fuse box contains various fuses for different electrical components of the motorcycle. Always consult the owner's manual for specific locations and fuse ratings.
One at a time.
the 1400 intruder didnt come out till 1987. nevertheless its at the back of the engine right near the battery box.
on the bottom of the motorcycle a door open to drop the battery down. loosen the bolt on the side ...but be careful the battery will drop down .
Suzuki VS 1400 Intruder, 1987 has an OHC fuel control. It weighs around 573 pounds and has Fuel capacity of 13. 00 liters or 3. 43 gallons.
The oil capacity for a 2000 Suzuki 1400 Intruder is approximately 3.5 quarts (or about 3.3 liters) when including the oil filter change. If you're just changing the oil without replacing the filter, the capacity is around 3.2 quarts (or about 3 liters). Always refer to the owner's manual for the most accurate specifications and recommendations for your motorcycle.
with a 10 mm wrench