place jack on frame or jack slant behind front tires. Better yet, purchase a pair of ramps and drive the vehicle up on them.
Drain pan, socket to fit the drain plug, new filter, correct weight oil, rags. You may need a floor jack and jack stands to change the oil in a car you must jack up to get under.
Raise the front of the Honda. With Jack and jack stands or ramps. Place your oil bucket/catcher under the oil pan. Then remove the drain plug on the bottom of the oil pan. Let the oil drain out. Then replace the drain plug. Then remove the oil filter and let drain into the oil bucket/catcher. Install a new oil filter and new oil. Lower the Honda back down. That's it. Save yourself $20 and have better products in your car.
what kind of hyderlic oil i have to put in jack
The oil drain plug on a 2003 Monte Carlo is located on the oil pan at the bottom of the engine. It is typically towards the rear of the vehicle, under the car, and can be accessed from underneath. To drain the oil, you'll need to remove the plug using a wrench or socket. Be sure to place a drain pan underneath to catch the oil.
Depends on the year, make and model vehicle and engine coolant drain, engine oil drain, automatic transmission oil drain, standard transmission oil drain, front differential oil drain and rear differential oil drain.
The oil drain on a 1985 club car is located beneath the engine block near the crankshaft. To remove the oil drain, you will need to use a standard size ratchet and extension.
To change the oil in a 1996 Oldsmobile Eighty-Eight, first ensure the engine is off and cool. Lift the car and secure it on jack stands, then place an oil pan under the oil pan and remove the oil drain plug to let the old oil drain out. Replace the drain plug, then remove the old oil filter using an oil filter wrench and install a new one. Finally, refill the engine with new oil through the oil filler cap, checking the level with the dipstick to ensure it's at the correct level.
Just remove the drain plug.
You will have to jack it up or put it on a lift.
If you jack up your car, it is located towards the front right in the middle, Its a screw you have to take out and your oil will start draining, make sure you have your oil pan close by!
Do you have your car on jack stands, or jacked up when changing the oil? If so you might want to see if the car is in a major incline (i.e. front of car up in the air.) If that is the case, then none of your oil is going to come close to your drain hole. its all in the back of the pan. THE CAR HAS 2 (DRAIN PLUGS) TAKE OUT BOTH & U SHOULD GET 5 QUARTS OUT INCLUDING THE OIL FILTER.(YES) TWO PLUGS ON THE SAME OIL PAN !IF THE CAR WAS ON THAT MUCH OF AN INCLINE - YOUR CAR WOULD BE STANDING ON IT'S BUMPER.
Yes, it is very easy to change your oil on a Ford Escape. You will need a socket wrench, and oil pan, and oil. Open the oil cap, jack up the car and place the oil pan underneath the oil pan on the SUV. Open the drain plug and let the oil flow into the oil pan. When done, close everything up and add new oil.