Here is how the Chilton Manual says to do it......
1.Raise and safely support the vehicle.
2.Disengage the cable from the transmission.->Disconnect the cable by pulling it out of the speed sensor. Do not attempt to remove the spring retainer clip with the sensor. 3.Disconnect the cable from its retaining clips
4.Push the cable through the grommet in the floor and pull it into the passenger compartment.
5.Disconnect the cable from the speedometer, cluster removal may be necessary.
6.Install the speedometer in position and route it through the floor.
7.Connect it at the speedometer and at the transmission.Hope this helps.
To fix the odometer on a 1986 Mercedes 190E, first, remove the instrument cluster by disconnecting the battery and unscrewing the fasteners. Carefully detach the speedometer cable and access the odometer mechanism. Inspect for broken gears or a stuck odometer wheel, and replace any damaged parts or lubricate them as needed. Reassemble the cluster, ensuring all connections are secure, and reconnect the battery to test the odometer functionality.
yes
Parts that old replace them with new ones.
pull the trans take out the old clutch and put a new one in then put it back together. or do what i do i buy a book on my ranger and fix it myself
To replace the rattling speedometer cable on a 1986 Caprice Classic, first, disconnect the negative battery terminal for safety. Then, locate the speedometer cable at the back of the speedometer gauge and the transmission; unscrew the cable from both ends. Remove the old cable and install the new one by securing it to the transmission and reconnecting it to the speedometer. Finally, check for proper function and reattach the battery terminal.
what is the mpg rate on a 1986 ford ranger 2.9 v6
Most under dash driver's side. There isn't an OBD port on a 1986 ranger!!
Rene Ranger was born on September 30, 1986.
Rene Ranger was born on September 30, 1986.
If service was performed on a 1986 Ford Ranger 2.9L and the code is still showing up, the computer should be reset. Disconnect the positive cable on the battery for a few seconds. This should take care of the problem.
The 1986 Honda Prelude does not have a clutch cable. The 1986 Prelude has a hydraulic clutch instead of the clutch cable.
Tommy Cable died in 1986.