answersLogoWhite

0

The car shakes because your engin has been cold and you sudenly start the car it will shake

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Why is my toilet still running even after the water has been turned off?

If your toilet is still running after the water has been turned off, it could be due to a faulty flapper valve or a problem with the fill valve. These parts may need to be replaced to stop the running water.


How long has good morning america been running for?

Good Morning America has been broadcasting since 1975. Traditionally the number two morning show, it recently overtook the Today Show for the top spot.


Why does your lawn mower shake while running?

Something is out of balance. The most common cause is blades that have been sharpened incorrectly.


What would cause your car to not crank after it has been running and then turned off?

Discharged battery possibly or trouble with starter.


Why does Acura Legend shake when braking?

More than likely you have warped rotors. Have the rotors and brakes inspected. If the rotors are not too bad and have not been turned before they can be turned and trued and used again. You will also need new brake pads.


Why wont my day time running lights stay on once my car engine has been turned off?

it would kill the batt.


Why does 1995 Acura Legend shake when braking?

More than likely you have warped rotors. Have the rotors and brakes inspected. If the rotors are not too bad and have not been turned before they can be turned and trued and used again. You will also need new brake pads.


Why does front end shake when you apply brakes at 60 mph?

Warped rotors are caused by heat. Perhaps you've been riding the brakes or you have a sticking caliper.Either replace the warped rotor or have it turned.


Your cars batterie died after you turned car off?

how old is the battery if it is a few years old replace it you may have been running on the alternator only


The laminar flow hood should be left operating continuously If it is turned off.it should not be used until it has been running for at least?

The laminar flow hood should be left operating continuously when in use to maintain the sterile airflow. If it is turned off, it should not be used until it has been running for at least 30 minutes to ensure that the air inside the hood is once again sterile.


What dance troupe hasn't been on shake it up?

diversity hasn't been on shake it up and i know that because i watch it allot because i am 12.


Why won't bronco II start after it has been running turned off then will turn over but will not fire?

It is either the coil,coil wire or the ign.module attached to the back of the distributor