answersLogoWhite

0

What else can I help you with?

Related Questions

How can you tell if the ignition switch is bad on a 95 Mercury Villager?

A bad ignition switch, on your 1995, Mercury Voyager, will cause the vehicle not to start. In most cases a bad ignition will cause the engine not to turn over.


What would cause my MPV VAN not to startit wont turn over just clicks.could it be a ignition switch?

could be the starter


What would cause a 1992 Honda Accord to not turn over?

Dead battery, defective starter or ignition switch. Loose connection.


Your 1999 Grand Am will not turn over when you turn the key on?

BAttery?, starter? ignition switch?


What starts a car?

The ignition switch completes the circuit of electricity from the battery to the starter that actually turn the engine over and starts it.The ignition switch completes the circuit of electricity from the battery to the starter that actually turn the engine over and starts it.


What would cause a Mitsubishi space wagon engine not to start and not even turn over?

Dead battery, bad starter, or defective ignition switch.


Ignition switch will not turn Replace?

Ignition switch 2002 Chrysler sebring. Original key will not turn? Is there a fuse or replace the switch?


What is the cause when you turn the key and your car takes a few seconds to 'turn over'?

It sounds as though your ignition switch is a little loose in it's socket and turns with the keywhen starting. Check the screw base of the ignition key holder and be sure it is screwed tightly down.


I have no power to my ignition when i turn the key over?

A person will have no power to the ignition when the key is turned over when the battery is dead or the ignition switch is defective. Each component must be tested to rule them out as a problem.


The key will not turn over in ignition it is locked?

Sometimes the Steering wheel lock will rest on the locking mechanism and not let you turn the ignition switch. Try turning the wheel one way or the other to relieve the pressure while tuning the ignition switch. If this does not work then you may either have a worn out ignition swtch, Key, or there is a mechanical failure of the switch.


How do you replace the ignition wiring harness and ignition switch?

you pull out the radio and dash cluster and you will have full access to the ignition just turn it over and un clip the wires


Starter wont turn over engine i have to touch connection with screw driver to turn van over?

loose wire somewhere from ignition switch to starter.