0
What else can I help you with?
Can a fuel pump let the car from cranking but not starting?
this question makes no sense ? i assume you mean prevent the car from cranking??? if so then no. a bad fuel pump may stop the car from running or starting but it should not stop it from cranking. a bad fuel pump relay could stop the car from cranking but that would depend on the year make and model of your car.
What stop a Mercedes Benz from cranking?
mines stop cranking because of a blown head
Do a ignition coil stop a Lincoln town car from running?
check your answer
What makes car stop after installing new coil module?
The brakes.
When cranking the motor why does the hot wire on the coil go out?
When cranking, the ballast resistor is bypassed to give a hotter spark. If during cranking you do not have power at the coil, but when the key is turned to run you do; there is a problem with the bypass circuit (sometimes it comes from the starter motor solenoid wire)
Will a frozen gas line stop your car from cranking?
The starter would still crank the engine but the engine will fail to run.
Why does your car stall out in the rain?
coil could be damp it should stop after you run for awhile
Battery is fine but cold cranking amps are low and car hesitates when cranking?
check battery and alternator
When cranking the car it cranks for a second and tries to move?
no
What makes your car cranking slowly?
Weak battery
How far should the voltage on a car battery drop when cranking the car?
when cranking the engine the battery voltage should not fall below 9.6volts if so replace battery
What would cause a 1981 Ford F-250 not to fire when you turn the key but it fires after you let go?
you have the ignition coil wired wrong you need to have 12v during crank and after to. sounds to me you have it hooked up so when your cranking it over its cutting out the 12v its like when you start your car and the radio shuts off till your done cranking it over well that what happens when you wire you coil up wrong... It has a bypass to the ignition that gives the coil 12 volts when starting and goes to about 8 volts when running. The bypass wire is not conected or broken
