a bad sinkero inside the trans
The clutch is not adjustable, it's hydraulic and as such adjusts itself. The problem you are describing is the result of a failed clutch system, typically a leaky hydraulic component.
Not on the clutch itself but on the clutch pedal there is one for starting.
Not with the clutch by itself.
problem in the clutch linkage or throwout bearing, check for binding in the exterior linkage before getting into the bearing, it may be worn or just binding on the shaft, could also be clutch itself as springs may be weak from time
Have a look at: Clutch slave cylinder Clutch cable More than likely the clutch itself has broken spring(s)
If it ain't the clutch itself then its prob. your slave or master cylinder.
Usually on the firewall, driver's side, opposite the clutch itself.
You don't adjust the clutch brake itself - that gets replaced. If you're trying to adjust the clutch itself, see the related question "how do you adjust a clutch on a Class 7 or 8 truck"... I've spelled it out there already
A hydraulic clutch requires no adjustment, as it constantly adjusts itself.....if you are having problems getting into gear then check your fluid level and bleed the system, if the clutch is biting too high then its probably because the clutch is worn. If after checking the levels and bleeding you still have problems, then it could be a release bearing problem ..
Remove the fan itself then remove the clutch from the fan
You can adjust the clutch pedal free play but not the clutch itself.
im sure this is on the clutch pedal itself.