high enough to read, just keep it away from lamps , they produce heat.
Some builders put the base all the way down in all areas. Works fine.
I have a 98 Chevy s10 vortek and I am rebuilding it, I am not getting coolent flow and was checking out the thermostat first before ripping off the water pump. I tested the therm. in boiling water and it opens only about a less then 1/16", is the water pump out or is the thermostat out? Thermostat. It should open almost a full inch. 1/16" is not nearly enough.
he's a dwarf
Mass extinction
it always depends on the person and their tolerence, but most people have a low tolerence when they start off so not that much.
To turn off the heater in your house, locate the thermostat and set it to the "off" position. This will stop the heater from running and heating your home.
A tiger's shoulder is approximately 3 to 3.5 feet off of the floor. :)
To install a thermostat in a house, first turn off the power to the heating and cooling system. Remove the old thermostat and label the wires. Install the new thermostat base and connect the wires according to the manufacturer's instructions. Attach the thermostat faceplate and turn the power back on. Follow the setup instructions to program the thermostat.
around 6 foot high
To install a thermostat in a house, first turn off the power to the heating and cooling system. Remove the old thermostat and label the wires. Install the new thermostat according to the manufacturer's instructions, connecting the wires to the corresponding terminals. Finally, turn the power back on and program the thermostat to your desired settings.
To replace the thermostat in your house, first turn off the power to the heating and cooling system. Remove the old thermostat cover and disconnect the wires. Install the new thermostat following the manufacturer's instructions and connect the wires accordingly. Finally, turn the power back on and program the new thermostat as needed.
To change a thermostat in a house, first turn off the power to the heating or cooling system. Remove the old thermostat cover and disconnect the wires. Install the new thermostat base and connect the wires according to the instructions. Attach the new thermostat cover and restore power to the system. Follow the manufacturer's instructions for programming and setting the new thermostat.
To install a thermostat in your house, first turn off the power to your heating and cooling system. Remove the old thermostat and label the wires. Install the new thermostat base and connect the wires according to the manufacturer's instructions. Attach the thermostat faceplate and turn the power back on. Follow the setup instructions to program your new thermostat.
Because that is its job! A thermostat is a device that measures the temperature of a given space or volume, and turns heating / cooling devices on and off accordingly. The thermostat in your house is designed to turn the heating off when the house is warm and turn it on when the house is cold. The thermostat in your car turns the radiator fan on when the oil / water temperature increases to a level that could be damaging to the engine (if you are stuck in traffic for example)
To change a thermostat in your house, first turn off the power to the heating or cooling system. Remove the old thermostat cover and disconnect the wires. Install the new thermostat according to the manufacturer's instructions, connecting the wires to the corresponding terminals. Finally, turn the power back on and program the new thermostat as needed.
The ideal location would be close to the floor, but the house structure limits location. It is common to see air return grilles on walls or ceilings.
you might have pulled a vacuum hose off