To calculate the amount of Quikrete needed for a slab measuring 5 feet by 8 feet, you first determine the volume in cubic feet. Assuming a standard thickness of 4 inches (0.33 feet), the volume would be 5 ft x 8 ft x 0.33 ft = 13.2 cubic feet. Quikrete typically comes in 60 lb or 80 lb bags, with each 60 lb bag covering about 0.45 cubic feet and each 80 lb bag covering about 0.6 cubic feet. You would need approximately 30 bags of 60 lb Quikrete or about 22 bags of 80 lb Quikrete to complete the slab.
This can't be answered because you have not given the third dimension. You must say how thick the slab is.
6.67 Cubic Yards
For this area you will need 2.4 cubic yards.
1.78 cu. yds.
2x2
I would get 12 to be safe.
To use Quikrete for a concrete project, follow these steps: Prepare the area by clearing debris and leveling the ground. Mix Quikrete with water according to the instructions on the package. Pour the mixture into the prepared area and spread it evenly. Use a trowel to smooth the surface and remove any air bubbles. Allow the concrete to cure for the recommended time before using it.
This can't be answered because you have not given the third dimension. You must say how thick the slab is.
Things that are viscous (pours out thick) are , but are not limited to, molasses, tar, honey, etc.
should be at lest 4 inches
4
Honey is an example of a liquid that is hard to pour due to its thick and sticky nature. Its high viscosity causes it to flow slowly and adhere to surfaces, making it challenging to pour smoothly.
about 25 yds
6.67 Cubic Yards
To use Quikrete 5000 concrete mix for a DIY project, follow these steps: Wear protective gear like gloves and a mask. Mix the concrete with water according to the instructions on the bag. Pour the mix into your project area and level it with a trowel. Allow the concrete to cure for at least 24 hours before removing any forms or finishing the surface.
As a guideline, 4 inches thick, but it would depend on what is going to be sitting on top of it. You may need thicker and/or to reinforce it with rebar.