Termination signal is at the end of the part of the chromosome being transcribed during transcription of mRNA. While in a stop codon, also called termination codon, is a nucleotide triplet within messenger RNA that signals a termination of translation.
the answer involves reversing the binding of signal molecule to the receptor
The termination of protein translation is caused by termination codon. Termination happens when a stop codon is reached, there is no amino acid to be incorporated and the entire assembly releases the newly synthesized polypeptide.
61 codons specify the amino acids used in proteins and 3 codons (stop codons) signal termination of growth of the polypeptide chain...so 64 total
The primary effector creates a signal that can diffuse within the cell. This signal is called the "secondary messenger." (The neurotransmitter is the first messenger.) The secondary messenger may then activate a "secondary effector" whose effects depend on the particular secondary messenger system.
one Major difference is confocal microscopy has confocality which means it reduces the background signal which is not presented in conventional fluorescence microscope usually termed as epifluorescence microscope
The main difference between the tow is the signal. VGA uses an analog signal and DVI is a digital signal.
processing is nothing
wave is a part of a signal . millions of wave construct a signal .
Distortion.
It stops the codon, so it cannot continue.
The basic difference is that in analog modulation the modulating signal is analog signal and in digital modulation it is in digital form.
SINR - Signal to Interference and Noise Ratio CINR - Carrier to Interference and Noise Ratio difference between those to is difference between carrier and signal carrier is signal who doesn't "carry" any information . it must be modulated( by phase,freq or amplitude) and those changes convey information. carrier is unmodulated signal signal is defined as useful signal which carries information SINR is power of signal to power of interfenence and noise ratio
the difference between both are: Primary transducer:The Mechanical device which converts physical quantity to be measured into a mechanical signal. Secondary tranducer:The Electrical device which converts this mechanical signal to the electrical signal.
1.wave is a three dimensional object where as signal is a two dimensional object
if a signal is a function of single independent variable,then signal is called multichannel signal. if a signal is function of multiple independent variable then signal is called multidimensional signal.
What are the differences typhoon signal and describe \
They are the same thing.