The sacroiliac joint is responsible for connecting the spine to the pelvis and transmitting forces between the lower extremities and the spine. The joint can become hyper or hypo mobile in response to an injury. This what is commonly called pelvic torsion.
In comparison to a male pelvic girdle, a female pelvic girdle typically has a wider pelvic inlet and wider pubic angle, allowing for childbirth. Additionally, the female pelvic bones are generally lighter and thinner than those of a male.
The pelvic inlet (surface that defines the border between the abdominal and pelvic cavities) in males is "andriod" shaped, i.e. heart or wedge shaped.
The term for the removal of the entire contents of the pelvic cavity is "pelvic exenteration." This surgical procedure is usually performed in cases of advanced pelvic tumors or recurrent cancer that involves pelvic organs such as the bladder, rectum, uterus, or cervix. It aims to achieve complete removal of the affected structures in the pelvis to prevent the spread of cancer.
The extension of the pelvis that encircles the apex of the pyramid is called the pelvic brim, also known as the pelvic inlet. It is the upper border of the pelvic cavity and is defined by the bony edges of the pelvic bones.
Yes, the abdominal and pelvic cavities are separated by the pelvic floor muscles, not the diaphragm. The diaphragm separates the abdominal cavity from the thoracic cavity, which contains the heart and lungs.
Torsion
Torsion means twisting or being twisted. Intestinal torsion can be fatal.
Vehicle does not have torsion bars
Instead of using coil springs on the front suspension torsion bars are used from the lower control arms to the frame ( my 1995 Ford Explorer 4x4 has torsion bars , my dads 73 Dodge Coronet had torsion bars ) If you look at a lower front suspension that has torsion bars you will see the torsion bars going from the lower control arms rearward
Spraining your ankle is typically caused by a torsion force, which is a twisting force that causes the ligaments in the ankle to stretch or tear.
I'm pretty sure that only 4WD trucks have torsion bars.
A Dodge Ram does not have torsion bars.
The tundra does not have torsion bars, buy a lift.
A 2WD Tahoe does not have torsion adjustment bolts, it uses front coil springs and not torsion bars.
The 1st generation Nissan Pathfinder, 1987 - 1995 had a torsion bar suspension on the front end of the vehicle. There is a driver's side and passenger's side torsion bar and they are not interchangeable. 1996 - 2009 models do not use a torsion bar.
There is a bolt near rear of torsion bar (the end closer to rear bumper) which will increase or decrease the tension on torsion bar when you adjust bolt.
Yes, a non-abelian group can have a torsion subgroup. A torsion subgroup is defined as the set of elements in a group that have finite order. Many non-abelian groups, such as the symmetric group ( S_3 ), contain elements of finite order, thus forming a torsion subgroup. Therefore, the existence of a torsion subgroup is not restricted to abelian groups.