answersLogoWhite

0


Best Answer

Distance and azimuth.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

6y ago

Distance and azimuth

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What should be pre-determined before using dead reckoning to reach your objective?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What should be pre-determined before using dead reckoning to reach your objective.?

Distance and azimuth.


Why should you look to the slide before you lower the objective of your microscope?

so the objective lens will not touch the slide.


Is the hypothesis before the objective?

The hypothesis is before you begin the expariment, so the first thing you should do is write down your hypothesis.


A microscope should be stored with the objective in place?

It should be stored with the low-power objective in place.


How long should my resume objective be?

How long should my resume objective be? Read more topresumetemplate .com


What should be my Objectives in a college?

If this is for acceptance, then your objective should be to get your degree. Be honest about it. If this is AFTER acceptance, find your career, then GRADUATE. That should be your main objective.


Which objective should be in place both when beginning to use the microscope?

Scanning objective


Which objective lens should you begin with?

The low power or lowest power objective


What is the objective of you training?

well ur objective should be getting better at the thing ur training about


Is intent in torts objective or subjective?

It can be both objective or subjective. Should have known, vs. Did know


What should you write as your career objective for the post of a lecturer?

You should write many things as your career objective for the post of a lecturer. You should include many facts and statistics.


What should be done after a stress cone is installed on a high voltage conductor termination?

Conduct a Hi-Pot test on the full length of cable (ensure safety and qualified operator) for a predetermined time at a predetermined voltage. Verify ground straps are properly earthed before test. Test results for a good stress cone installation will be about 35-50 Micro-amps.