When water reaches boiling, it becomes steam. Once the water cools down, typically below 100 degrees Fahrenheit, it will begin to form water droplets or condensation.
Gland staem condenser is meant for condensing the steam whichwas used for sealing the LABYRINTH GLAND and reusing it d cycle. It is then passed through d drain cooler and LP heaters and so on......
Yes, spores can be effectively killed when exposed to steam sterilization at high temperatures, typically around 121-132°C (250-270°F). The high temperature and pressure of steam sterilization are able to denature and destroy the spores' genetic material and proteins, rendering them nonviable.
Yes, it is true. The average kinetic energy of gas particles is directly proportional to their temperature according to the kinetic theory of gases. So, when the temperature doubles from 100 to 200, the average kinetic energy of the steam particles also doubles.
Chromatin condenses into chromosomes during cell division in order to facilitate the orderly segregation of genetic material into daughter cells. This condensation helps ensure that each daughter cell receives the correct complement of chromosomes.
Chromosomes condense and form during the prophase stage of mitosis. This is when the chromatin fibers in the nucleus tighten and become visible as distinct structures through a microscope.
When it is under 100 degrees celsius
Either reduce its temperature or increase the pressure on it, and provide something on which the steam can condense.
That depends on what type of liquid created the steam. Obviously, different liquids have different evaporation, boiling, and melting points.
Approximately 30,000 gallons of water is required to condense one ton of steam.
rise temperature, increase the insulation. Also, air does not own much mass. It will not condense the steam faster and much.
DRY steam is superheated There is a temperature below which steam will start to condense into water droplets. This is called the saturation temperature, and it varies with the pressure of the steam. Steam that is exactly at its saturation temperature is called saturated steam. Steam that is below its saturation temperature contains droplets of moisture and is called wet steam. Steam that is above its saturation temperature is called superheated steam.
nothing
At the same temperature, water molecules have the same amount of energy, whether in the form of solid ice, liquid water, or gaseous steam. When cooled at this specific temperature, the kinetic energy of water molecules decreases, causing them to come closer together and form a solid (freeze) or a liquid (condense) depending on the initial state of the water.
Warm air (at least warmer than the outside temperature) rising out of the storm sewers causes moisture in the air to condense.
1400K
Clouds and steam are forms of evaporated water. Water is the main base for evaporation to occur. Bot clouds and steam can condense in a cool temperature, while water can bothe condense and evaporate. So they are not much alike.
the work of the condensor is to condense the hot steam and change its state so that it can be used again in boiler