answersLogoWhite

0

The person breathes in oxygen and breaths out carbondioxide back into the spirometre. Because the carbondioxide can become a saftey hazard, soda lime is placed in the spirometre to remove the carbondioxide, however the volume of carbondioxide is equal to the volume of oxygen, as the oxygen is not being replace, so removing the carbondioxide removes the oxygen as well, making the spirometre drop.

User Avatar

Wiki User

11y ago

What else can I help you with?

Continue Learning about Biology

How do you properly read a P200 micropipette?

To properly read a P200 micropipette, first set the volume to the desired amount by turning the dial. Then, place the tip of the micropipette into the liquid and slowly press the plunger to draw up the liquid. To read the volume, look at the display window on the micropipette, which shows the amount of liquid in microliters.


How to properly pipette to ensure accurate measurements?

To properly pipette for accurate measurements, first ensure the pipette tip is clean and secure. Use the correct pipette size for the volume needed. Hold the pipette vertically and immerse the tip into the liquid. Depress the plunger slowly and steadily to draw up the liquid. Release the plunger slowly to dispense the liquid. Avoid introducing air bubbles and always wipe the tip before dispensing.


How do you properly use a pipette to transfer liquids in the laboratory?

To properly use a pipette in the laboratory to transfer liquids, first select the appropriate pipette size for the volume needed. Then, attach a disposable tip to the pipette. Press the plunger to the first stop to draw liquid into the pipette, and then release it slowly to dispense the liquid. Be sure to hold the pipette vertically to ensure accurate measurements. Dispose of the tip after each use to prevent contamination.


How to use pipettes effectively for accurate measurements?

To use pipettes effectively for accurate measurements, first ensure the pipette is clean and calibrated. Hold the pipette vertically and draw the liquid to the desired volume. Release the liquid slowly and steadily, making sure the meniscus is at the correct mark. Avoid introducing air bubbles and always use the appropriate tip size for the pipette.


In the kidneys the largest volume of water reabsorption occurs in the?

The largest volume of water reabsorption in the kidneys occurs in the proximal convoluted tubule. This is the first segment of the renal tubule where approximately 65-70% of the filtered water is reabsorbed back into the bloodstream.

Related Questions

How to calculate per minute how long a 5200 liter water tank will take to half fill at a rate of 7 liters per minute?

Basically two steps. First, you calculate how much volume half the tank would have. Then you simply divide this volume by the rate.


How do you calculate IV drops per minute?

To calculate IV drops per minute, you need to know the total volume of fluid to be infused (in milliliters) and the infusion time (in minutes). First, divide the total volume by the infusion time to find the flow rate in mL per minute. Next, multiply this flow rate by the drip factor (drops/mL) provided by the IV tubing to determine the number of drops per minute. The formula is: Drops per minute = (Total volume in mL / Total time in minutes) × Drip factor.


How many sit ups can a 15 year old boy do in 1 minute?

It will depend on your fitness level. You should try and build up slowly. dont do to much at first!!


What does lung capacity have to do with healthy lungs?

Lung capacity is measured by a spirometer giving you this measurement.Total Lung Capacity = vital capacity + reserve volume = approximately 6 L.Any less than the normal volume will cause a loss of gas exchange. It may not seem much at first but if it progresses, it can lead to the what might be called suffocation. You can not get enough oxygen in the lungs for cell metabolism and it will finally lead to death.


How do you find the volume of a rock given a graduated cylinder?

If the rock is small enough to be put into the cylinder, then fill the cylinder first with water to a known level (the graduations will usually indicate the volume). Then slowly drop the rock into the cylinder without splashing. Now read the level of the water (again the graduations will usually indicate the volume). Subtract the first reading from the second and that would be the volume of the rock.


First four minute mile?

The first 4 minute mile was run by Roger Banister.


What is the first minute of the first hour of a day?

The first minute of the dat is the 60 second interval from 12:00:00 AM (midnight) through 12:00:59 AM. This is the "0 minute" which is the first minute of the day. Time is expressed as a measurement similar to a ruler and not a count as in a yearly calender.


What are some opinions about Texas?

First, (Apparently) EVERYTHING is BIGGER in Texas. Secondly, Nothing "Lives" in Texas, it just Dies slowly... and last: Welcome to Texas, If you Don't Like The Weather wait a "MINUTE" it will Change


How do you read a buret accurately?

To read a buret accurately, first ensure it is clean and dry. Record the initial volume reading at the bottom of the meniscus. Then, add the liquid slowly while swirling the buret gently. Record the final volume reading at the bottom of the meniscus. The difference between the initial and final readings is the volume dispensed.


When was The First Minute of a New Day created?

The First Minute of a New Day was created on -19-07-06.


How do you convert hertz to gallons per minute?

To convert hertz (Hz) to gallons per minute (GPM), you first need to understand the context of the measurement. Hertz measures frequency (cycles per second), while gallons per minute measures flow rate. If you know the volume of fluid being moved per cycle, you can multiply the frequency (in Hz) by that volume (in gallons) to get the flow rate in gallons per minute. For example, if one cycle moves 1 gallon of fluid, then 10 Hz would equal 10 GPM.


What is the name of the first volume of akbar nama?

Akbarnama-I is the first volume of the akbarnama.