50 to,1
Anywhere from 300-500 lbs.
generally speaking if it has valves its a 4 stroke 4 cycle engine......if it doesnt have valves then it is a two stroke 2 cycle...................
To check the oil in a 2001 Mercury 90hp 4-stroke engine, first, ensure the engine is level and turned off. Remove the dipstick, wipe it clean, then reinsert it fully without screwing it in and remove it again to check the oil level. The oil should be within the marked range on the dipstick. If necessary, add the appropriate oil type to reach the correct level.
it is on the rear of the engine below the engine. There is a rubber hose coming out of the motor and the drain plug is inside the rubber hose.
The approximate weight of a 90hp Chrysler outboard motor is 280 pounds.
no - the shaft and splines are too big do you know where there is a 90 yam gearbox for sale
For a 90hp Mercury two-stroke outboard, you should use a high-quality lower unit gear lube specifically designed for outboard motors. Mercury recommends using their own brand of gear lube, such as Mercury High-Performance Gear Lube or Quicksilver Gear Lube, which offer excellent protection against wear and corrosion. Always check the owner's manual for specific recommendations regarding viscosity and any additional requirements.
The maximum speed of the 1962 Volvo 122 4cyl 90hp is 99 mph.
The maximum speed of the 1973 Renault 17 TL 4cyl 90hp is 69 mph.
The maximum speed of the 1962 Porsche 1600 s 4cyl 90hp is 100 mph.
About 115kg on a 98.