0
What else can I help you with?
How does a 1993 Kawasaki 750 SS jet Ski cool?
Well how does a 1993 Kawasaki 750Ss jet ski cool? The motor of the 1993 750SS and all other two stroke jet skis cool with water that flows through the water jackets of the motor and the exhaust. I will further explain this using jet engine theory. A jet engine sucks in air, squeezes the air, and the blows it out the back end, which in case makes the plane or car move very fast. Well in case of a jet ski, it sucks the lake or ocean water in through the intake grate on the bottom of the ski, runs it through the different areas of the motor and the jet pump, (squeezes it)and then shoots it out the jet nozzle on the rear of the ski, in which case propels the ski through the water. The more throttle the rider gives the ski, the faster the process goes and thus the faster the jet ski will move.
Will Kawasaki 750 Jet Ski motor fit in a 650 Jet Ski hull?
yes with some changes
Where do you find help on a jet ski?
You could practically ask any Jet ski Motor specialist for help.
Can a jet ski pull a man skiing?
yes, if your jet ski has a big enough engine. we have a 701 engine and you can get pulled out of the water
What Size of motor in my jet ski?
the vin# is kaw27661E090
Where is the trim motor on a Kawasaki jet ski?
The trim motor on a Kawasaki jet ski is typically located near the rear of the watercraft, often mounted on or near the jet pump assembly. It is responsible for adjusting the trim angle of the jet ski, which affects its handling and performance. Accessing the trim motor usually requires removing the rear seat or the engine cover, depending on the model. Always consult the specific service manual for detailed instructions relevant to your model.
What would be a good motor boat for a teen?
Jet ski
What do you do if your jet ski has been sitting?
Remove the spark plugs, dump in some 2 cycle oil over each piston, replace the spark plugs, turn the engine over 1 or 2 times, Let the Jet Ski stand for a while.
Where can I find Parts for a Suzuki jet ski engine?
You can find parts for a Suzuki jet ski engine at most Suzuki dealers and auto parts stores. You can also find these types of parts online at places that sell jet ski accessories and parts.
Can jet ski be beached and is it safe for the jet ski?
Yes, a Jet Ski can safely be beached as the impeller is hidden. However, it is recommended that you kill the engine before actually reaching land. And beaching the Jet Ski is hard on it's under surface - that takes a toll over time.
Can you crank a jet ski out of the water?
Yes. You can crank and start a jet ski out of the water. However, without water, there will be no cooling for the engine, exhaust, and driveline. So generally it is not recommended to let the engine run more than a few seconds. Many people crank a jet ski out of the water to prime the fuel system prior to placing the jet ski in the water.
How do you replace jet ski 1997 starter motor?
To replace the starter motor on a 1997 jet ski, first, disconnect the battery to ensure safety. Remove any necessary panels for access, then locate the starter motor, which is typically mounted near the engine. Disconnect the electrical connections and remove the motor by unscrewing it from its mounting. Install the new starter motor by reversing these steps, ensuring all connections are secure before reconnecting the battery.
