0
What else can I help you with?
Can you install a wake tower on to a fish and ski boat with an outboard motor?
Yes you can. You have to know 2 things about your boat: 1. Can you pull someone out of the water with your motor? ( for a 16 ft fiberglass boat you need at the very least 80hp, but a 120 does better) 2. Do you have a place to mount the tower and not have it rip out? There is a lot of pressure on that thing
What size boat engine do you need to pull a skier?
You can pull a skier at around 17ktns so even with a smallish outboard (25hp) on a dinghy its possible.
Can you pull a tube with a 6 hp outboard motor?
Yes, but not very fast.
Will a 50 hp outboard motor pull a tube?
i have a 50 hp force on a 18 foot invader boat a i pull one just fine only shows problem when u have three or more on tube so have fun
Does a Johnson 135 outboard motor have enough power to pull a water skier?
It all depends on your boat first and the actual skiers to a lessor degree. If you have smaller ski or fishing boat (19' or shorter), then that is more than enough power to pull whatever or whoever you want to with it. I am 6'1" and stocky in my earlier days, but I have skied behind a 17' bass boat with a 70 hp outboard pretty effortlessly. If your boat is 20' or larger, then it comes down to the weight of your boat, the type of prop you have, etc. and it is less likely that you will be skiing much with that boat/motor combination. **Worse case, try it... You will either pull the skiier up, or not. Remember too that you can change your prop to a power take off prop that will give you more BITE from a dead stop for this situation, but takes a little of your top end speed away.
How do you adjust idle on 1996 25 hp Mercury outboard boat motor?
== Is this engine the plastic cowling with idle knob and choke knob on the front pull it to choke and turn to raise idle? = Read more: http://www.justanswer.com/questions/1dpbt-25-hp-mercury-outboard-water#ixzz0HH1RenQM&B
Can a 115 hp outboad motor pull up a skier?
Yes, a 115 hp outboard motor can typically pull up a skier, especially if the skier is relatively lightweight and the boat is designed for towing. Most recreational waterskiers can be towed with motors in the 70-115 hp range, provided the boat is properly equipped with a ski tow bar or ring. However, factors such as the weight of the boat, the number of passengers, and water conditions can affect performance. Ensuring the boat is within its weight capacity and the skier is skilled can enhance the towing experience.
Can a 50 hp motor pull a skier?
Assume you are talking about a boat and a water skier. Yes it will work. I have been towed by a 35 HP outboard. It depends on the skill of the skier to be able to get up quickly. It also depends on the skis and the drag they cause while being pulled from the water.
If you run aground on an outboard boat what is the first step to free the vessel?
If you run aground on an outboard boat, the first step to free the vessel is to assess the situation and ensure everyone's safety. Then, shift the boat into reverse while gently applying throttle to help dislodge it from the ground. If that doesn’t work, consider using a small anchor to pull the bow out or shift weight towards the stern to reduce the draft. Avoid excessive force to prevent damage to the boat or the environment.
Installing an electric starter on 1979 mercury outboard motor 20hp.manual start. please help.?
Don't know that but where can I get a starter kit for a 1975 mercury 20hp 2 stroke motor. I can't pull the rope anymore. to old I guess
Is it easy to pull start an 40hp mariner outboard?
yes
Will 50 HP pull one skier?
Yes, a 50 HP motor can typically pull one skier, depending on factors such as the skier's weight, water conditions, and the boat's design. Generally, a properly set-up boat with 50 HP is sufficient to tow a single skier effectively. However, for optimal performance and safety, it's essential to ensure that the boat is stable and that the skier is within the weight limits for the motor's power.
