answersLogoWhite

0

First make sure that the outer tube and the inner tube groove are lined up. Sometimes these jacks get twisted and they are out of alignment. Next if it is a side wind jack then you have to check and make sure the gears are in good working order, they may have to be replaced.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

When was Jack Atwood born?

Jack Atwood was born on February 27, 1908, in USA.


When did Jack Atwood die?

Jack Atwood died on January 5, 1984, in Maine, USA.


What is the thing called that moves your trailer up and down?

The device that moves your trailer up and down is called a trailer jack. It is a mechanism that helps you to lift and lower the trailer to attach or detach it from your vehicle.


When is a trailer most likely to jack knife?

On slippery, slick roads.


Difference between hi power and vip barker trailer jack?

limit switch in the hi power.none in the vip.this stops the motor at the end of the travel whether up or down


When operating an electric pallet jack before entering a trailer that is not is not attached to a tractor always make sure that answer it?

when operating an electric pallet jack before entering a trailer that is not attached to a tractor always make sure that answer it


What is the song in the movie trailer quicksilver?

Smilin' Jack Casey by Tony Banks


What is the name for the small wheel in front of a trailer that is used to raise and lower it?

a jack


Is a tongue jack required to be on a boat trailer?

A tongue jack is not legally required on all boat trailers, but it is highly recommended for convenience and safety. It helps in easily attaching and detaching the trailer from the towing vehicle, as well as stabilizing the trailer when parked. Ultimately, the decision to use one may depend on the size and weight of the boat and trailer, as well as personal preference.


What actors and actresses appeared in Trailer Trash - 2005?

The cast of Trailer Trash - 2005 includes: Tim Gato as Jack Carrie LaChance as Charlene


How do you hook up a load stabilizing trailer hitch?

hook trl. to hitch then jack up trl. to desired ride level then hook and bind the chains to a snug fit (not to tight not to loose then let jack back down the truck and trl. should be level.


When operating an electric pallet jack before entering a trailer that is not attached to a tractor always make sure that?

When operating an electric pallet jack before entering a trailer that is not attached to a tractor, always ensure that the trailer is properly secured to prevent it from moving or tipping over. Check that the trailer's landing gear is stable and that wheel chocks are in place if necessary. Additionally, confirm that the trailer is clear of any obstacles and that the area is safe for operation. Finally, never enter a trailer without verifying that it has been properly docked or secured.