answersLogoWhite

0

I just changed the oil in my Mercury 60 hp 4 stroke and had very little clean up. I let the oil completely drain from the motor before I removed the filter and had No drips there either. Just over 30 minutes to change motor oil and lower unit oil. Total cost of $35.00 included quicksilver 25W40 quicksilver oil filter and quicksilver 80/90 gear oil. Take your time and save your money . No reason to pay a dealer $150 to $250. for this simple oil change. Charliestoybox

User Avatar

Wiki User

9y ago

What else can I help you with?

Related Questions

Where is the oil drain plug on Mercury outboard motor?

where is the drain oil plug on a 2010 9.9 mercury outboard motor


How do you change oil in a 2007 60 hp four stroke mercury bigfoot outboard?

To change the oil in a 2007 60 hp FourStroke Mercury BigFoot outboard, start by warming up the engine briefly to thin the oil, then turn it off. Remove the oil drain plug located at the bottom of the lower unit and allow the old oil to fully drain into a suitable container. Replace the drain plug and use a pump to add new oil through the dipstick tube until it reaches the appropriate level on the dipstick. Finally, run the engine for a few minutes, check for leaks, and recheck the oil level, adding more if necessary.


How do you Oil change on 4 stroke 90 hp mercury outboard?

Web site never did answer the question.


How do you change engine oil on a 9.9 horsepower 4 stroke Mercury outboard motor?

whereiscrank case oil drain plug on 1998 mercury 9.9 4 stroke


How do you winterize 2.5 mercury outboard?

what type oil to use on 4stroke 2.5mercury outboard


How do you change lower unit oil in 50 hp mercury outboard?

Take it to a marine repair shop or google it up, the answer is there


What is the proper fuel oil mixture for mercury 5hp outboard?

I have a 1999 Mercury 2stroke 5HP outboard and the owners manual states 50:1 Gas/Oil mixture.


What is the proper gas to oil ratio mix for a mercury 1750 outboard motor?

A 175hp Mercury outboard requires a 50:1 fuel to oil ratio.


What is gas to oil ratio for a 2.2hp mercury outboard?

2%


What is the ratio of gas to oil in a mercury 80 hp outboard?

If manufactured after 1965, an 80 hp Mercury outboard requires a 50:1 fuel, to 2 cycle oil ratio.


What is the amount of gear oil in lower unit on a 1973 7.5 hp mercury outboard?

The 1973 model, 7.5 hp Mercury outboard, requires 6.8 oz. of gear oil.


What is the fuel mixture 4 hp mercury outboard?

A 4hp Mercury outboard requires a 50:1 fuel to 2 cycle oil mix.