To check the oil on an older Yamaha WaveRunner, start by ensuring the engine is off and the watercraft is on a level surface. Open the engine compartment and locate the oil dipstick, usually found on the oil reservoir. Remove the dipstick, wipe it clean, reinsert it without threading, and then remove it again to check the oil level. The oil should be between the minimum and maximum marks; if it's low, add the appropriate oil as specified in the owner's manual.
In order to flush a 2002 Yamaha Wave Runner you will first need flush kit. These kits make it simple to flush out water and sand.
You find the engine size in the name 1993 Yamaha wave runner model WR500, WR500 being the engine size.
150 hp
The 1992 Yamaha 650 Wave Runner typically uses a 15-amp fuse for its electrical system. It's important to check the owner's manual or any labels on the fuse box for specific recommendations, as some configurations may vary. Always ensure that the replacement fuse matches the specified rating to avoid electrical issues.
WaveRunner is made by Yamaha, Jet Ski's are made by Kawasaki.
1200000 yamaha is way better then ski doo polaris and artic cat (aka kittie cat nothing is good about them
The last person is probably dragging their feet.
to keep the water from getting through the exhaust back to your motor.
50/1
if you really want it, keep asking until you get it. A whiney voice usually helps.
they are under the 4 black spark plug wires held on by the 10mm bolts.
Hi, can not find my plug on hull either, was told they have a bilge pump that pumps it all out.