answersLogoWhite

0

on the end of the cowl away from the gas line enterance the is a square handle. inside the handle on each side there are two leavers. push the leavers down and the latch is released for the cowl to be lifted off.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you remove a cowl off a mercury outboard motor 90hp?

There is a lever at both the front and rear of the cowl, the front one pulls forward, the rear one pivots up. Once these are released the cowl will lift straight up.


How is lower cowl secured on mercury9.8hp outboard motor 1973 vintage.?

The lower cowl on a vintage 1973 Mercury 9.8HP outboard motor with 4 retaining bolts. They are passed through the cowl and directly into the body of the boat.


How do you remove cowl on mercury 7.5 hp outboard?

My 7.5 Merc is an early 80's model, and it has a release located on the left hand side as you face the front (control side) of the motor. Pull that release, and lift the rear side of the cowl first.


How do you remove the cowl on 1999 Mercury Grand Marque?

To remove the cowl on a 1999 Mercury Grand Marquis, first, lift the hood and locate the cowl cover, which is typically secured with several screws or clips. Remove these screws using a screwdriver or socket wrench. Carefully lift the cowl cover away from the windshield, ensuring not to damage any clips or seals. Finally, disconnect any attached wiring or hoses if necessary before fully removing the cowl.


Does 115 optimax outboard have on board oil resivoir undfr cowl?

yes


How do you remove the cowl on a 2006 form mustang?

* Remove the windshield wiper arms * Remove the retaining fasteners securing the cowl cover * Remove the right side cowl cover then the left side


What is the procedure for removing the cowl on a ford 2006 mustang?

# Remove the windshield wiper arms # Remove the retaining fastners securing the cowl cover # Remove the right side cowl cover then the left side


How do you remove the wiper cowl on a 1998 town and country?

Remove the wiper arms first. Then remove the torx screws that hold the plastic cowl in place.


How do you replace the front wiper motor on a 1997 Mercury Villager?

The wiper motor is located in front of the windshield under the cowl grille. 1. Remove both wiper arms.2. Remove six screws from the cowl grille at the base of the windshield.3. Open the hood.4. Remove the four plastic screwsand anchors from the forward edge of the cowl.5. Disconnect the washer hose and lift the cowl grille from the car.6. Locate the wiper motor on the driver side7. Remove the three bolts that hold the motor and the shaft nut that holds the wiper arm.8. Remove motor.


How do you replace the wiper motor on a 1995 Mercury Grand Marquis?

remove the wiper arms, remove the cowl covers, remove the cowl assembly, that is, the big plastic thing that the wiper motoe sits in. It is held is with about five or six 8mm bolts. Unplug the wiper motor and turn the assembly upside-down to access and replace the wiper motor.


Where is the blower resistor located on a 1994 Dodge Shadow?

under the cowl, remove wiper arm assembly, remove cowl, remove windshield washer resvior (sp) and you will find it


Outboard Motors oil mix for suzuki 2hp?

on the cowl of my 1993 DT2 suzuki it states 100 to 1 mix.