0
hi, The shift cable connects to a rocker arm that then connects to your shift rod, on most out boards there is a nut located underneath the carb's that you would remove. but in your case you must loosen the rocker arm (5/8" bolt) enough to get the pin out of the shifter rod, once the shifter rod is loose/not connected you take out the 7 bolt's that hold the foot on, off. then you will see the black plastic housing that hold the impeller take off the 4 bolt's and the impeller is off. I hope this helps
What else can I help you with?
What is the spark plug gap on a 1977 85hp Johnson outboard?
Champion L77-JC4 plug set to .030in.
What is the gas to oil ratio for a 1980 85HP Johnson motor?
50:1 16oz per 6gal tank
How much oil does the foot of a 85hp Johnson outboard take?
An 85hp Johnson outboard typically requires about 2 to 3 quarts of oil for its lower unit. It's important to refer to the specific owner's manual for your model to ensure accurate measurements and proper maintenance. Always check the oil level and use the recommended oil type for optimal performance.
What is the weight of a 1990 Yamaha 85hp outboard motor?
The dry weight of an 85hp Yamaha outboard is 245lbs.
What is the horn noise on a 1976 85hp Evinrude outboard motor?
On the 1976 model, 85 hp Evinrude, the overheat circuit is the only alarm system on the engine. Check the temperature on each head, due to independent thermostats, for an overheat condition.
What is the compression on a 1978 Johnson 85hp?
The compression ratio for a 1978 Johnson 85hp outboard motor is typically around 130 to 150 psi per cylinder when measured with a compression gauge. It's important to ensure that all cylinders have similar readings for optimal performance. If compression is significantly lower in any cylinder, it could indicate issues such as worn rings or a blown head gasket. Regular maintenance can help maintain good compression levels.
What is the maximum speed of the peugeot 404 4cyl 85hp 1963?
The maximum speed of the 1963 peugeot 404 4cyl 85hp is 104 mph.
How do you make compression higher on Johnson outboard 85hp?
To increase compression on a Johnson 85hp outboard, you can start by ensuring that the cylinder heads are in good condition and properly torqued to specifications. You might also consider replacing the head gaskets with thinner ones to reduce the combustion chamber volume. Additionally, checking and potentially replacing rings or pistons can help improve sealing and compression. However, any modifications should be approached cautiously, as they can affect engine performance and longevity.
What is the maximum speed of the sunbeam alpine cabriolet 4cyl 85hp 1962?
The maximum speed of the 1962 Sunbeam Alpine Cabriolet 4cyl 85hp is 99 mph.
How fast is a Yamaha 85hp outboard motor?
60kph
How old is a mercury 85hp Blue Band outboard motor serial number 3867469?
An 85hp Mercury outboard, serial number 3867469, is a 1974 year model.
What is the maximum speed of the Volvo 122 s 4-cylinder 85hp 1961?
The maximum speed of the Volvo 122 s 4cyl 85hp 1961 is 92 mph.
