0
What else can I help you with?
How do you change a water pump impeller on a 2003 40 hp Mercury EFI 4 stroke?
Pull the lower unit look into moter leg you will see th water pump on the shaft you may have to pull the shaft to get it but from ther its just bolts on the pump.
When did mercury start making 4 stroke outboards?
Mercury Marine began producing four-stroke outboard engines in the late 1990s. The company introduced its first four-stroke outboard, the Mercury 4-Stroke 15 HP, in 1999. Since then, Mercury has expanded its four-stroke lineup, focusing on performance, fuel efficiency, and environmental compliance.
What is the Mercury 3.5 Hp four stroke valve clearance?
What is the Mercury 3.5 Hp four stroke valve clearance?
1965 mercury 50HP thunderbolt 2 or 4 stroke?
two stroke
Which is faster 15 hp mercury 2 stroke or 15 hp mercury 4 stroke?
The 2 stroke will be faster because of differences in Waite but more polluting be it oil mixed with fuel
Is a mercury 850 outboard motor a 4 stroke or 2 stroke?
The 850 model, 85 hp Mercury outboard, is a 2 stroke engine requiring a 50:1 fuel to oil ratio.
What is the weight of 2002 75hp 4 stroke Mercury outboard motor?
The dry weight of a 2002 model, 75hp Mercury outboard 4 stroke, is 386 lbs.
What is the weight 78 mercury 80 hp outboard 2 stroke?
could you please tell me the weight of a 1980 mercury 80hp 2 stroke outboard motor
Is a 25 Mercury 4 stroke about the same as a 40 Mercury 2 stroke in power and weight?
A 25 HP Mercury 4-stroke engine generally produces less power and is lighter than a 40 HP Mercury 2-stroke engine. The 2-stroke design typically offers more power for its size due to its different combustion process, while 4-stroke engines are usually heavier and more fuel-efficient. Therefore, the 40 HP 2-stroke would have greater power output and potentially a different weight profile compared to the 25 HP 4-stroke.
How do you change oil in a 2007 60 hp four stroke mercury bigfoot outboard?
To change the oil in a 2007 60 hp FourStroke Mercury BigFoot outboard, start by warming up the engine briefly to thin the oil, then turn it off. Remove the oil drain plug located at the bottom of the lower unit and allow the old oil to fully drain into a suitable container. Replace the drain plug and use a pump to add new oil through the dipstick tube until it reaches the appropriate level on the dipstick. Finally, run the engine for a few minutes, check for leaks, and recheck the oil level, adding more if necessary.
What is the weight of a mercury 25 hp 2 stroke 1989 outboard?
The 1989 model, 25 hp Mercury 2 stroke outboard, has a dry weight of 112 lbs.
How do you change engine oil on a 9.9 horsepower 4 stroke Mercury outboard motor?
whereiscrank case oil drain plug on 1998 mercury 9.9 4 stroke
