answersLogoWhite

0

Turn the trim tab to the left some

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Fix low compression in outboard motor cylinder?

You have to take out the cylinder, how low is it, what is the difference


How to fix outboard motor underwater?

firstly u should take out the spark plugs and give it 50 pulls then put them back in and run it for at least half an hour but 3 to 4 hours on an extra oil fuel mix is best


How do you fix a carbureter from a 71 mercury 45hp outboard motor?

This is a fairly vague question to answer, but generally all that is needed for an outboard carburetor is a good cleaning, and to install a new gasket kit. Hope this helps.


How do you fix a impeller on a Chrysler 25 horsepower outbourd?

This is how to fix the impeller on a Chrysler 25 HP outboard motor. Disconnect the coupling that's on the outside of the leg, flip the housing and twist in impeller.


Why won't my Yamaha outboard motor start?

There are several possible reasons why a Yamaha outboard motor may not start, including issues with the fuel system, spark plugs, battery, or ignition system. It is recommended to check these components and consult a professional mechanic if needed to diagnose and fix the problem.


Will JB weld fix the crack i have on my outboard motor's mounting bracket?

It will fill in the crack, but it will not add any strength to the bracket. I would recommend either brazing or replacement of the cracked part.


How do you fix a mercury outboard motor when it doesn't squirt water out all the time?

Change the water pump impeller, they get old and need replacing every 5 years or so depending on wear.


How do you change impeller on mercury outboard 7.5 hp motor?

First off, make sure it is not just stuck. This can be accomplished by adding lubricating oil to the empeller. If that doesn't do the trick, then refer to manufacturers directions to fix the problem.


Where is the PVC on a 1992 Dakota?

It is located on the valve cover. It is usually white, or used to be white, and it has vaccum hoses connected to it. It pulls right out of the valve cover. Easiest fix on the truck.


How can your car still pull right after you got an alignment and your car still pulls to the right?

You have a defective component. Do not take it back to the same place. If the next place can fix the problem, you should be able to get a refund from the first place.


How do you fix a cylinder with low compression on an outboard?

This all depends on why it has low compression. If the rings are worn out, the motor should be rebuilt. If one of the valves is bad, re grinding it or replacing them is the fix. Perform a cylinder leakage test to confirm it. You will probably need to take it to a shop for this, but unfortunately, there usually are no quick fixes for low compression.


How do you fix a dryers motor?

Replace it.