0
What else can I help you with?
What is a jet ski drain cable for?
To drain the jet ski, of course. This is needed after washing the bilge but they are usually opened after removing the ski from the water to let any water that has accumulated in the bilge drain out.
Where is the water drain in a 1989 kawasaki jet ski?
In a 1989 Kawasaki Jet Ski, the water drain is typically located at the rear of the watercraft, near the bottom of the hull. It may also be near the engine compartment where any excess water can exit the ski. It's important to check the owner's manual for specific locations and maintenance tips related to the drain. Always ensure the drain is clear to prevent water accumulation.
What does a jet ski do?
A Jet Ski is a watercraft. It's more like a motorbike only in water.
Where can you drive a jet ski?
in the water.
Can you crank a jet ski out of the water?
Yes. You can crank and start a jet ski out of the water. However, without water, there will be no cooling for the engine, exhaust, and driveline. So generally it is not recommended to let the engine run more than a few seconds. Many people crank a jet ski out of the water to prime the fuel system prior to placing the jet ski in the water.
Why does your jet ski hull fill with water?
There are a lot of reasons. If the drain plugs aren't in, that would do it. Also, the impeller shaft seals or carbon ring may be worn. One way to tell is to get the jet ski dry, place it in the water, and then run it with the seat off. You should be able to tell where the water is coming from.
What should you do if gasoline is poured into a jet-ski oil tank?
Drain the oil, and refill.
Where is the drain plug for a 1990 650 kawasaki ts jet ski?
At the bottom of the lake.
Do jet ski have brakes?
No they don't. The force of the water against the front of the jet ski will stop it when you slow down. :)
How does a jet ski powered jet pack work and what are its main features?
A jet ski-powered jet pack works by using water propulsion from a jet ski to lift the rider into the air. The main features of a jet ski-powered jet pack include a harness for the rider, a hose connecting the jet pack to the jet ski, and controls for steering and height adjustment.
Why does a jet ski pump water out the exhuast?
A jet ski pumps water out of the exhaust as part of its propulsion system. It uses a jet propulsion mechanism that draws water from the body of water, pressurizes it, and then expels it through the exhaust. This process not only creates thrust to propel the jet ski forward but also cools the engine by circulating water through it. The expelled water creates a visible spray, which is characteristic of jet ski operation.
How do you get on the jet ski?
you get on a jet ski by A: pushing it out into the water and sitting your knees on it and start then gas it and then stand at your own pace or B: push it out into the water and having one foot on it and the other off then start the jet ski and gas it and immediately stand up
