0
What else can I help you with?
What should the compression be for a 50 hp 4 stroke Mercury outboard motor?
125 is the least
What should the compression be at on a 150 hp mercury outboard motor?
I should be equal on all cylenders and about 110 to 120
What is the cylinder compression for a 1999 135hp mercury outboard?
should be at least 100 PSI and the difference between cylinders should be less than 10% of each
What is the cylinder compression for a 2003 90 hp mercury outboard?
I have a 2005 and compression should be close to 120 psi. Normally a good engine will have compression between 115 and 130 psi but a leak down test should be performed also to know the full condition of a cylinder.
What is compression on 1975 70 hp evinrude outboard?
Compression on a 1975 70 hp Evinrude outboard refers to the pressure generated within the engine's cylinders during the compression stroke, which is crucial for efficient combustion. Typically, compression readings for this model should be between 90 to 120 psi. Low compression can indicate issues such as worn piston rings, damaged cylinder walls, or valve problems, which can affect engine performance and reliability. Regular compression testing is essential for maintaining the health of the outboard motor.
What should the compression be on a 2000 125hp Mercury outboard?
The compression for a 2000 125hp Mercury outboard should typically range between 100 to 150 psi per cylinder, with a maximum variation of about 10% between cylinders. It's important to ensure that all cylinders are within this range to ensure optimal performance and engine health. Regular compression testing can help identify potential issues before they lead to more significant problems. Always refer to the specific service manual for your engine model for the most accurate specifications.
What should be the Compression on 150 hp 2 stroke mercury outboard?
For a 150 hp 2-stroke Mercury outboard, ideal compression typically ranges from 90 to 120 psi per cylinder, but it can vary based on the specific model and age of the engine. It's important to check the manufacturer's specifications for the exact model. Consistent compression readings across all cylinders are crucial; a significant difference may indicate engine wear or issues. Regular maintenance and checking compression can help ensure optimal performance and longevity.
What should the spark plug gap be in a Mercury 110 9.8 outboard?
.040
Hi you have an older ted Williams 7.5 horse outboard engine and you need to know what the compression should be or close to be?
A 7.5 hp outboard will need around 90 - 100 psi of compression to start up and run. Anything over this pressure is a bonus. Also, you want there to be no more than 10 - 15 psi difference between cylinders.
What should compression be 2004 4 stroke mercury?
For a 2004 four-stroke Mercury outboard engine, the compression should typically be around 120 to 150 psi per cylinder, depending on the specific model. It's essential to ensure that the compression readings are consistent across all cylinders, ideally within 10% of each other. If compression is significantly lower in any cylinder, it can indicate issues such as worn rings or valve problems. Regular maintenance and checks can help maintain optimal engine performance.
What should the normal compression be on a 1997 Johnson 15 hp outboard motor?
between 90-120
What is the weight of a mercury 9.8 hp outboard?
Should be right around 65 pounds
