The general consensus is 4 to 8 times the maximum expected depth, depending on the weather. In really deep water the scope (length of line or chain) will be less though because the ship probably doesn't have more than 150 fathoms of chain.
3X
There are two ways Anchoring way of floating docks:1.If water is less than 3m in depth, steel piles are to be put in proper place and then connected by wheels, which can prevent the floating dock from moving laterally but can automatically rise and fall in line with water level.2.If water is over 3m in depth, anchoring can be used by sinking the anchorage block pulled by steel cables to the water bottom.
No, the buoyancy of a PFD does not change based on the depth of the water. The buoyancy of a PFD is based on its design and materials, not the depth of the water. It will provide the same level of buoyancy regardless of the water depth.
60
5 inches! The water depth should be about the shell length.
If that's where the water is. At that depth, it should be fairly good water, well filtered by the time it get to that depth.
It depends on how deep the water is you are anchoring in. If you use all chain then multiply the depth by 3 and add enough extra chain to reach from the water surface to your cleat. If you use all rope then multiply the depth by 5 and add enough rope to reach from the water to your cleat.
At 300 feet of water depth the pressure is about 130 psi
Depth of water
the length should be 8 times the depth of the deepest water you are planning to anchor in.
It depends on the depth of the water. The hydrostatic pressure increases with depth.
ndbenhv Chadic hat